You can program new keys to the system if you have two valid sentry keys by performing the following procedure: # Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code # Insert the first valid key into the ignition switch and turn the ignition switch ON for at least 3 seconds but no longer than 15 seconds. Turn the ignition switch OFF and remove the first key. # Insert the second valid key and turn the ignition switch ON within 15 seconds. After ten seconds a chime will sound and the Theft Alarm Light will begin to flash. Turn the ignition switch OFF and remove the second key. # Insert a blank Sentry Key into the ignition switch and turn the ignition switch ON within 60 seconds. After 10 seconds a single chime will sound. The Theft Alarm Light will stop flashing, turn on for 3 seconds; then turn off. The new Sentry key has been programmed. Repeat this procedure to program up to a total of 8 keys. If you do not have a programmed sentry key, contact your dealer for information.
Hi I am now trying to do the same with my 106 key fob, after reading on the internet it seems the way to do it is to -
1. unlock drivers side door with the key
2. within 20 seconds aim the key at the sensor and press twice
the second press should lock the doors and it is now complete. Although this method hasn't worked for me, but I believe that may be something to do with something else.
Peugeot 106 workshop manual.
Fob is short for finger operated button. It is usually used to describe the remote for a car locking system.
Find out what type of battery the fob takes, and then replace it. If you are in the middle of nowhere, then i dont know.
Press UNLOCK on your key fob twice
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
well, I'm gussing it'sgonna have something to do with thescrew under the key, but I'm not sure past that I'm afraid!
If you have recently changed the battery, you may have issues with the key fob operating the locking system. The key fob must be reprogrammed, which you can do yourself first before taking it to a shop.
If the battery has been out of the key fob for too long the fob loses its program and the car will not start. Peugeot will try to charge £48 for a reprogram but you can get around this by: - 1) Turn on the ignition 2) Hold down the close button for a few seconds 3) Turn off the ignition and remove the key 4) Start the car The above can be found on page 19 or 20 of the 407 user manual
How do you program a key fob to a 2003 Chevy Malibu
To program any kind of key fob you have to take it to a dealership.
How do I re program my key fob for renault laguna estate 1997?
Peugeot 106 workshop manual.
To add a new key fob, take the vehicle and the key fob to an authorized dealer. To re-program a key fob after replacing it's battery, open the key fob, then read and follow the instructions inside.
http://www.ehow.com/how_7456283_program-key-fob-harley-davidson.html
The key fob programing requires the dealer's scan tool.
It is possible to program one key fob to use on two different cars. If the key fob uses a primitive fixed code system, programming two cars will not work.
there isn't one, usually a key