first erase any previous code by pressing and holding 2 outside buttons, releasing only when indicator light begins to flash after 20 seconds Then hold the hand-held opener within 2 to 5 inches from the Mitsubishi's transceiver, keeping the indicator light in view. Using both hands, simultaneously push the hand-held transceiver button and the desired Mitsu button. Do not realease until you see the indicator light flash, first slowly and then rapidly. When the light flashes rapidly, release both buttons. Test by pressing the newly programmed button.
This information is listed in your owner's manual.
My owner's manual recommends 5w 30
If you are looking for a specific code, it should be listed in your owners manual. Look in the manual under radio.
You will need 4 quarts of oil for an oil change for a 1997 Mitsubishi Diamante. Refer to your owner's manual for complete details, recommendations, and instructions.
Look in your manual
The owners manual tells how to program the garage door buttons good luck Cliff
The owners manual will tell you how to do it.
read your manual.
Look in your owners manual or take it to the Chevy garage.
REad the owners manual. But I believe you have to put garage opener in learn or program mode then depress and hold button on the Yukon this will allow it to program itself to you door remote
The dealer service manual says 60,000 miles. But, on the Diamante forum there are cars with 180,000 miles on the original belt. Sounds scary! This is a "interference" engine. This means that if the belt breaks, the valves hit the pistons and cost a lot!!!
Try homelink.com The steps are also in the owners manual.