answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you properly hook up a solenoid on a 89 Ford Ranger 2.9 L V6 4x4?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you hook up an tac in a ford ranger automatic?

you need to hook it up on the distributor


How do you hook up a selinoid on an 85 ford ranger 2.0 4 cylinder?

Starter solenoid? Battery + cable to large lug Starter cable to the other large lug Trigger wire to small lug (if 2 disregard 1)


Where is the hook up for the obd 2 on a 99 ford ranger?

under the dash on the drivers side.


What wires do you need to hook up on a 1985 ford Econoline 150 to get it to start?

Try a jumper from + battery to + coil Then jump small trigger wire at solenoid to large cable that runs to starter at solenoid MAKE SURE IT IS IN NEUTRAL IF STD.


1993 ford tempo changed the solenoid it started now it does nothing replaced the battery but it acts as tho there is no battery in it any suggestions?

make sure the small wire is hook to the post


Changed starter solenoid on 86 ford bronco and when you hook up the battery the engine trys to start without you turning the key?

Check you connections make sure there on the correct way.


What order do the sparkplugs hook up to the coil pack in a 2000 ford ranger 3.0 leader?

coil----3---4 pack---2---6 plug----1---5


How do you hook up a tachometer to a 1996 ford ranger 2.3 letter engin?

just open the by hood smashing it and just start beat off and call bill klutzon the vehicle


How do you check the windshield wiper motor in a 2000 ford ranger?

You can hook wire leads from the battery to the plug terminal and a ground. If it works then the pump is good. If not, then wiring may be an issue or a relay or fuse.


When replacing a three terminal starter solenoid with a 4 terminal on a 1987 Ford Ranger 2.91 how do you hook it up so it will not drain the battery?

One small terminal is labeled "S" and that is hooked up as before. The 4th small terminal is labeled "I". Leave alone as if it was not there. It goes to ignition coils on some cars, but if you did not have that before leave it disconnected. The other two large terminals are the same. George


Can you hook up a car seat to a 1999 ford expedition xlt?

Yes, you can hook up a car seat to the Ford Expedition


What is the stereo color coded wiring diagram on a 2008 ford van?

The stereo color coded wiring diagram on a 2008 Ford van is what shows you how to hook up a different stereo system in the vehicle if you choose to do that. The purpose of the diagram is so you hook the new stereo up correctly and all features and speakers work properly.