0
How do you hook up a selinoid on an 85 ford ranger 2.0 4 cylinder?
Wiki User
∙ 16y ago
Starter solenoid? Battery + cable to large lug Starter cable to the other large lug Trigger wire to small lug (if 2 disregard 1)
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you hook up an tac in a ford ranger automatic?
you need to hook it up on the distributor
Where is the hook up for the obd 2 on a 99 ford ranger?
under the dash on the drivers side.
What order do the sparkplugs hook up to the coil pack in a 2000 ford ranger 3.0 leader?
coil----3---4 pack---2---6 plug----1---5
How do you hook up a tachometer to a 1996 ford ranger 2.3 letter engin?
just open the by hood smashing it and just start beat off and call bill klutzon the vehicle
How do you check the windshield wiper motor in a 2000 ford ranger?
You can hook wire leads from the battery to the plug terminal and a ground. If it works then the pump is good. If not, then wiring may be an issue or a relay or fuse.
Can you hook up a car seat to a 1999 ford expedition xlt?
Yes, you can hook up a car seat to the Ford Expedition
How do you hook up your plug wires on a 1988 Ford Ranger?
I'd replace the wires on at a time. I have a special plug wire puller pliers that helps to avoid breaking the wires if you can't get them off the sparks plug.
How do you bleed a master cylinder for a 1991 Ford Tempo?
Before bleeding the master cylinder, you must first intall all parts so that you can hook up the master cylinder as soon as it has been bled. The best thing to do is get a manual for your vehicle that explains the do-it-yourself techniques because it will have pictures to go along with the directions.
How do you hook up a tow bar to a Ford Mustang?
How to hook up tow bar to 2004 mustang
Where is the starter on 1994 ranger?
on the driver side underneath, it right by you tire and it hook up to your tranny
How do you test the crank shaft sensor on a 91 ford ranger?
Answeryou will have to hook up a scan tool to see if you have cranking rpm with motor spinning over. rpm singal. also when you crank the engine the check engine light will go out if it is working
How do you set timing marks on a 94 ford probe?
1st take out the 1st cylinder spark plud bring the cylinder to the top then set the rotor to the mark before the 1st cylinder firing pin then on the distributor gear there in a thin line line that up wit line on the block then slide in the distrubutor then hook up everything if it doesn't work u did domething wrong
