answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-12-26 03:27:47
Answeryou will have to hook up a scan tool to see if you have cranking rpm with motor spinning over. rpm singal.

also when you crank the engine the check engine light will go out if it is working

001
๐ŸŒŽ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
1
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

Is there any adjustment to a crank shaft position sensor on a 1996 ford ranger 2.3 liter?

no


Were is the crank shift sensor at on a 94 ford ranger 4.0?

Where is the crank sensor located on a 94 ranger 4.0 motor


Where is the crank position sensor located on a ford 350 xl 5.8 liter?

The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.


Where is the crankshaft sensor located on a 1997 ford ranger 2.3 L?

The crank shaft sensor is located jusy behind the harmonic balancer just to tge left as you are facing the engine.


Does a 1988 Ford Mustang have a crank shaft position sensor?

I think you mean CAMSHAFT position sensor.


Where is the turbine shaft speed sensor on a 1996 Ford Ranger?

This engine has no turbine or turbo. Although the 1996 Ford Ranger does not have a turbine or turbo, it does have a turbine shaft speed (TSS) sensor. It is located inside the automatic transmission.


Where is the crank shaft positioning sensor located on a 94 ford probe?

2.0ltr its in distributer


Crank sensor 4.0 1993 Ford Ranger?

Next to the crank pulley. Held on with 2 10mm bolts.


92 ford ranger has no spark new module crank sensor?

its junk! crush it!


Where is crankshaft positioning sensor located on 1986 ford van?

A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer


What could be wrong with your 91 Ford Ranger 23L if it won't start or get spark after you took out the coils and replaced them if all the wires look good?

bad crank shaft position sensor


Where is your crank shaft located on a 2000 ford expedition?

The engine crank shaft is inside the engine


Where is the crankshaft position sensor and the camshaft position sensor located on a 1994 Ford Thunderbird 4.6L?

the crank shaft position sensor should be behind A/C compressor.


On a 1994 ford ranger the crank position sensor it brakes the magnet off the sensor and there is not enough adjustment to stop it how can you stop that?

On a 4.0 V-6 the crank position sensor is in a fixed location and cannot come in contact with the crank if it is installed correctly.


Where is your crank sensor on your 94 Ford Probe?

there are twoCrank sensors on the ford probe GT. One is located in the distributor that control spark and by taking the passenger front wheel off and to the right of the crank shaft pully you will see a one bolt device with three wires, that is your lower crank sensor.


Where is the crank shaft positioning sensor on a 1998 Ford Mustang with 3.8 liter?

The crank sensor is located on the bottom of the timing cover under the right hand side of the water pump by the crankshaft pulley.


Is the crank sensor attached to the timing belt cover on a 1995 ford ranger?

The crankshaft position sensor is located at the front of the engine close to the crankshaft damper


Where is the rev counter sensor for a Ford Ranger 2.5TD?

Where is the ford ranger 2004 revcounter sensor conected


1995 ford crown Victoria how to repair crank sensor?

2002 ford crown Victoria how to repair crank sensor?


Where is crank sensor on 1996 Ford F-250 5.8?

What position is the crank sensor on a f250 ford pickup


Where is the speed sensor for Ford Ranger 1993 located?

It should be in the tail shaft of the transmission. That's where mine is on 94 auto transmission.


Where is the speed sensor in a 1986 Ford Ranger?

Check the tail shaft of the transmission, if not their it is in the top of the diff housing, but that is mostly newer modles.


Where is the crank sensor located on a 6.0l ford power stroke diesel?

where is the crank sensor located on a 6.0l ford power stroke diesel


Where do you find a crank sensor on a Ford Aspire?

The crank sensor is located on the front side of the crank pulley, between the pulley and radiator.


Where is the drive shaft?

where is the driveshaft on a 2005 Ford Ranger