Want this question answered?
Where is the fuse panel that contains the radio fuse?
Check your Toyota owner"s manual, if it show you yes , then do it!
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
The cover surrounding the stereo just clips on, give it a good pull toward you and it will pop off, the stereo will be right there...
Pull out the ashtray and then the panel above and the cup holder . Radio will then come out
In my 2000 Toyota Corolla CE fuse for the radio is located at the back side of the radio, you need to pull out the radio and you will see the fuse on the back side of it between wires
Engine oil dipstick is accessed under the drivers seat. Release the seat, tilt back, pull up the access cover. The engine oil dipstick is there along with the Automatic Transmission dipstick (if it applies). Vehicle should be on level ground.
Underneath the driver's seat is a yellow switch.Push on the switch and flip the seat back.There's a knob that twists,Twist the knob and pull off access panel.There you will find the throttle cable to adjust idle.Any other questions contact sommercr@aol.com, I'll help if I can :)
pull out the battery or what ever is in front of it , or get a flash light and get your hands in there. it cant be that hard , you must atleast look at the back or call Toyota to see if it is poossible to remove the bulb and how to do it
loosen up the bracket that holds the tension on the belts then tigten up the adjustement bolts that pull the bracket then re tighten the bolts.
Pull the black trim that goes around the radio, it just pops out..... once you get that off, then there is a couple of screws on each side of the radio (on the bracket), remove those, and just pull the radio (with brackets attached) out, then remove the brackets from either side of the radio.
remove the screws and then apply pressure using your hands over the light housing pulling or pushing, whatever is easy for you, it has to be "slide out". I used the help of a flat screwdriver to pull the metal SNAP CLIP from the hole that that hold the light in place. do it very carefully. I hope this one help.