answersLogoWhite

0


Best Answer

Not sure on the explorer but I did rear brakes on a Taurus ( 98) & the piston turned in. I used a set of channel locks & turn them counter clock wise. There is a tool for this.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you push in the rear calipers on a 1998 Ford Explorer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Are the calipers in the front disk brakes of a 2001 ford explorer sport trac screw in or push in?

Push in. I've change my front pads several times and they compress straight in.


On a 1998 Ford Taurus do the rear brake calipers screw in or push in?

AnswerIf the emergency brake cables attach to the calipers SCREW INIf the emergency brake cables are separate, they PUSH INSee "Related Questions" below for more


How do you tune the radio in ford explorer xlt 1998?

Its all push button and there are no internal adjustments. If the radio or the buttons aren't working right, there is a problem that will have to be serviced by a technician.


1993 Ford Explorer push button 4x4 4dr no power to switch motor on transfer case?

i have a 1993 ford explorer push button 4x4 and when i push the button it kicks in but every 20 yards or so it makes a loud binding sound. what could that be?


How do you put a master cylinder back on a 2001 Ford Explorer sport?

How do I put on a 2001 ford explorer cylinder? I am in the process of changing my front brakes and the cylinders will not push back in?


How do you turn fog lights on in 1997 Ford Explorer?

On a 1997 Ford Explorer : The push button switch to turn on and off the fog lights is in ( the center stack of the dash , to the right of the radio )


How do you use 4 wheel drive in a 1991 ford explorer xlt?

push the 4x4 on dash


1996 ford explorer 4.0L push rod engine vacuum diagram or picture?

Picture


How do you know if your 1994 ford explorer 4.0 l is a push rod or a sohc v6?

It's a push rod V6 - VIN " X " 8th " character " ( Ford didn't start using the 4.0 liter SOHC until some of the 1997 Explorer models , VIN " E " )


Where is the 4WD button on the explorer?

From 1995 to 2001 Ford Explorer 4 doors it is a rotary dial on the left side of the CENTER STACK of the dash. From 2002 to 2005 Ford Explorer 4 doors , there are 3 vertical push buttons on the right side of the CENTER STACK of the dash From 2006 on, Ford Explorer 4 doors, there are 3 horizontal push buttons on the CENTER STACK of the dash located above the heater/ air conditioning selector dial. (Helpfull)


How do you remove the hydraulic line for the clutch in a 1995 Ford Explorer?

push in on line and push the plastic bushing that is on the connector up inside the connector itself to release it.


Can not locate the on off switch to the fog lights of 1998 ford explorer 2 door sport?

I believe the push button switch for the factory fog lights is in the center stack of your dash , just to the right of the radio , near the bottom of the radio