0
There are numerous web sites devoted to this very subject. There are also many kits designed for this purpose. Do a Google Search with the term "S-10 V8 Conversion"
AnswerYou will have to change the motor mounts, transmission mounts, transmission, driveshaft and rear end. You might have to modify the fire wall. I did it in my S10, its a lot of work but it ran 11s in the 1/4 mile sure the motor hade wrkd done to it by this is somthing you wound do in a week end and to do it right you need to spend some money dont have ass it because it will cost you in the long run
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you take a 1994 Chevy caprice 350 LT1 and put it into your 1993 Chevy Suburban 350 TBI after you switch intakes and put in the distributor?
Yes you sure can
Where do you put coolant in 1994 Chevy s10 pickup?
where do i put coolant in for 1994 Chevy s10 pickup
Can you put 1993 Chevy 350 heads on a 1977 350?
Should bolt right up... that motor didn't change for 40 years.
Where can you put the knock sensor of a 1989 Chevy silverado 350 tbi when doing a Chevy s10 350 conversion because the motor mounts are in the way of its original spot?
In place of the coolant drain plug on either side of the block.
Do you put transmission fluid in a standard trnsmission in a 1993 Chevy s10 pickup?
no evreyone knows that buddy no evreyone knows that buddy
Can you put a 350 Chevy engine in a 1985 s10 blazer without changing transmissions?
No, you can't. transmissions bellhousing is different in 60° V6 and L4
Will an Oldsmobile 350 engine fit into 1989 blazer?
You can put in a Chevy 350 motor using special motor mount plates from Summit or any other performance parts place. If you have access to a welder and some time, you could do it. Google Chevy S10 motor swaps and do some research... You can put in a Chevy 350 motor using special motor mount plates from Summit or any other performance parts place. If you have access to a welder and some time, you could do it. Google Chevy S10 motor swaps and do some research...
What do you do if the trans is stuck in 4hi on a 1993 Chevy s10 blazer?
What i do is put it in reverse and go about 10 feet and brake a little hard then put it in drive. it always works for me when that happens
Can you put a 1991 Chevy 350 engine on an older Chevy Turbo 350 transmition?
yes
Why did Chevy put a 4.3L in the s10?
Because it is a good engine.
Can you put an 8ft truck camper on a Chevy s10 truck?
No.
How do you put on shock absorbers on 1993 Chevy S10?
If it is a 4x4, for both the front and rear you can simply unbolt them and put new ones in, they are not under load because the springs support the weight of the vehicle.
