Make sure that the replacement lamps are the correct and same wattage.
Remove the 5 amp fuse from the fuse block in the glove box and temporarily install a 10amp fuse and turn ignition on and check lights.
The fault should have reset and therfore replace the fuse with a 5amp fuse.
The central fuse block is located under the right side of the dash on the right side footwell. The brake light fuse should be in there.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
Depends on in which way they are not working / in need of repair.See "Related Questions" below for replacing bulbs & a discussion about the brake light switch mounted at the brake pedal.These are 2 of the most common 'fixes'.
No, it is a brake light.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
you can't reset the brake light the computer automatically detects problems so if it hasn't shut off after a few engine cycles there is a problem with your braking system
The brake light switch is on a bracket just above the brake pedal.
You can access the middle brake light from the inside of your 2000 Dodge Neon cargo compartment. Remove the brake light wiring harness. Remove the brake light retaining bolts. Reverse the process to install the new brake light.
I'm replacing the brake booster on a 2000 kia sephia and how do you ajust both rods on the brake booster?
The left brake light works the right brake light doesn't and the bulbs is good
The brake light switch is located under the dash. It is connected to the upper arm on the Brake pedal
how to replace the brake light switch at the pedal of a 2001 ford zx2