With a scan tool.
Using a scan tool is one way to get the HVAC system fault codes.
In the 99/04 Jeep Grand Cherokees, you can also read the fault codes from the dashboard heater control module without a scan tool.
To read the fault codes from the dashboard heater control module:
1. Turn on the ignition switch.
2. Turn on the AZC system. The temperature settings should be displayed for both sides.
3. Simultaneously hold down the AC and the Re-Circ buttons.
4. Then turn the driver's side temperature (Left) control knob to the right (CW) one click.
5. Then release the AC and Re-Circ buttons.
If there are no fault codes, the "00" display value will remain in the window.
If there are any codes, each will be displayed for one second in ascending numerical sequence (note: no effort is made to display faults in the order they occurred). The left side set temperature display will be blanked and the right side set temperature display will indicate current and historical codes (8 historical max) presently active.
Once all codes have been displayed, the system will repeat the fault code numbers. This will continue until the left side set temperature control is moved at least one detent position in either direction, by pressing both the A/C and Recirc buttons at the same time, or the ignition is turned off.
P0700 indicates a fault in the Transmission control system. -My list does not show any 17- - codes for this car
Hook up a laptop with the appropriate software to read Cat fault codes.
In order to find instructions on how to read the fault codes of a 2000 Freightliner FLD 112 with a C12 engine you should go to heavydutypowertrain.com where they have an extensive selection of instructional material including how-to videos.
scanning for codes will indicate if the CPS is at fault.
Trouble code P0000 means: No fault found
It needs to be connected to diagnostic equipment for the fault codes to be read and then cleared.
the connection is on drivers side at bottom of dash, where driver sits. use a obd2 scanner to extract codes. if any codes you can use scanner to erase codes when fixed.
Battery? No spark? No fuel? Any trouble codes in the computer?
The ABS light is on because there is a fault in the system. Once the fault is repaired or fixed the light will reset itself. The ABS system can be scanned for codes to help diagnose the problem.
The steering colums was changed on my 2000 buick park avenue and it still wont start. do I need to get the security light to go off first
Try disconnecting battery for about 10 mins. or have vehicle scanned and codes cleared
Have the transmission computer checked for codes. It will lock into 2nd gear when a malfunction is detected.