You do not need to flush. Remove the drain plug on the oil pan, remove the filter, apply oil to the gasket on the filter, replace the filter, reinstall the drain plug after all the oil has drained out, pour in the correct amount of oil, and start the engine. Check for leaks, and you are done.
flush it dissconect both hoses and lfush it out good then refill with coolant flush it dissconect both hoses and lfush it out good then refill with coolant
You don't flush a manual transmission. You just drain the old fluid, and refill with new.
No, you can just refill if you like.No, you can just refill if you like.
The radiator on a 1995 Saturn is flushed by draining the coolant, refilling the engine with water, and adding a flush. It is allowed to circulate and drain before refilling with coolant.
Drain, flush, and refill.
there is no lower radiator hose.
To flush the coolant in a 2002 Toyota Echo you will need to drain it first. Flush with fresh water and then refill with coolant and distilled water.
go to the auto store and buy some prestone flush. instructions are on the back. basically you drain your radiator, pour in the flush, refill the system with water, run the engine with the heater on high for about 15 minutes, then drain the system again, refill it with 50/50 coolant.
Add Engine Flush to the motor oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 minutes. Then change the oil and the filter. Engine Flush is compatible with all commercially available motor oils. We recommend cleaning the engine interior with Engine Flush before every oil change.
remove bottom radiator hose to drain system. flush system a few time before adding antifreeze.
Drain and properly dispose (recycle) the old coolant. Put one bottle of Radiator Flush(from am auto parts store)in the radiator and refill with water. Run the car a idle(leave the heater ON to flush the heater core)for approx. 5 minutes. Drain and properly dispose of the flush liquid. Refill radiator with 50/50 mix of coolant and water or all premixed coolant.
Remove the coolant reservoir, flush it out, reinstall it and refill with proper coolant.