you need a serpentine belt tool, you can get one at auto zone or any part store. the alternator is on a pully system with a belt tensioner. place the tool in the tensioner and pull down, this releases the tension and the belt should come off. besure that you have the proper routing diagram and the correct belt for your engine size and year.
Also if you don't want to buy s serpentine belt tool, you can use a 15MM wrench.
need to replace alternator on a ford expediting 2003
Release the tension using a wrench etc from the idler pulley.
There A bolt half inch located outside a plate of the alternator on the fire wall side turn it counterclockwise either with a long wrench from on top or under the car
Disconnect the 1982 Regal alternator. Loosen the alternator bolts and slide to release belt tension. Put new belt on ( you may have to remove other belts to gain access) and pull the alternator sideways to put medium tension on the belt while tightening the bolts. Reconnect the battery.
i need to change my alternator belt and don't know where the tension wheel is so i can take off the other belt to replace the alternator belt on my 94 Mazda protege 1.6l
Take of te passenger tire and the shrouding that is there. The tensioner is on the other side of the shroud release the tension from the belt remove the belt. the alternator has two or three bolts holding it in place remove the and the wire from the alternator plus the plugs.
By loosening the tension on the alternator nut
Apply a wrench to the center bolt on the pully and turn it will adjust the tension.
You must first loosen the alternator, do not remove it. remove the alternator tension screws top and loosen the bottom screws DO NOT REMOVE push the alternator toward engine, for the a/c belt you must loosen the belt tension pulley and move it. replace in reverse order
"First Remove the Tension bolt from the alternator and remove." "Next take a hammer and gently tap the alternator down" "Do the same with the Tension Mount" "After realigning the alternator and the Tension mount replace the bolt" "BE CAREFUL NOT TOO TIGHT ON THE BELT OR YOU WILL RUIN THE BEARINGS" "GOOD LUCK"
The 93 Acclaim has a serpentine belt. The tensioner below the alternator is what keeps the tension. If you have not tension I would replace the belt first and then check the tensioner.
loosen the tension on the belt with the tension pulley, remove the belt then disconnect your wires from the alternator then take the 3-4 bolts, holding the alternator on, off. then do the opposite to put the new one back on