Chevy Blazer
Chevy Blazer S-10
Chevy Colorado

How do you release the parking brake pressure to replace the rotors on a 2000 4X4 Chevy Blazer LT?

234

Top Answer
User Avatar
Wiki User
Answered
2008-03-22 02:56:58
2008-03-22 02:56:58

There is a tension adjustment on the driver side just forward of the rear wheel.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?

how do u replace fule pressure regulator in 94 blazer vortec

Service brakes - replace Master cylinder Parking brake- either lubricate or replace cables ; I had a similar problem with my 1999 Chevy blazer, i ended up replacing the caliper and have had no problems since.

low pressure on you MAP sensor clean it or replace it

Chevrolet Blazer parking brake can be adjusted with the adjustment screw on the parking brake pad. The parking brake can also be adjusted with the parking brake cable.

On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.

it's in the high pressure side of the ac line

how do i replace a heater core in a 2001 Chevrolet blazer

how do you replace dome light in s10 chey blazer?

how to replace a heater core in a 1997 Chevy blazer

Drop the tank, take it off. and put a new one on!

First you have to remove the main beam.There are a couple of clips that you pull up that hold these in. Once those are out of the way there are a couple of tabs on the parking light that you squeeze together to remove the parking light. I've included a video that will show you how all of this is done.

how do you replace seatbelt retractor on a 2000 chevy blazer

Location of blower fan on 2001 blazer

have the transmission rebuilt Itll cost about $1600

locking mechanism is buggered.. have to unlock manually and replace

The 2003 Chevrolet Blazer OBD 2 port is on lower edge of dash; right of parking brake pedal

Lower the tank, pop out the old one and pop in the new one. A little lubrication helps.

The 1997 Chevrolet Blazer OBD 2 port is on lower edge of dash; right of parking brake

The oil pressure switch on a 1997 Chevy Blazer is located on the bottom of the engine, near the oil filter. It monitors the output and pressure of the oil pump.

replace the line and fill and bleed breaks.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.