# Simple, loosen lug nuts. Jack the truck up high enough that oil stays on oppsite u are working on. Meaning only jack up side u are working on. Then take ur lug nuts off and tire off. then take brake line loose. Then take emergency cable off. Then look behind drum there is 4 nuts around axle on back of drum cover. take thoose 4 nuts off. and axle will slide right out.
how do u remove cv axle driverside 1991 toyota corolla
take the bolts out
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
No, the frames are different. In 1986 Toyota went from a solid front axle design to independent front suspension. Therefore the frames are different.
Get a manual from a parts store and it has pictures and all.
remove the 10mm bolt and remove it.disconnect plug at other end.
Block up the ATV with the rear end off the ground. Remove both rear tires. Remove the brake assembly(brake drum, etc). Should be two locking nuts that hold the axle in place. remove those nuts. Axle slides out the passenger side
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
Remove the front tires, from your Pontiac Grand Prix. Remove the brakes and rotors. Unbolt the axle from the suspension. Remove the axle.
Yes, if you remove the front axle first.Yes, if you remove the front axle first.
My Toyota Sienna 2000 axle nut measures 30 mm Sprayed the threads as I will be replacing an axle shortly. Probably the same size.