Want this question answered?
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
The 1997 Chevy 1500 pickup truck 5.7 liter engine knock sensor can be found on the front of the engine. You will need to remove the front engine cover in order to access the sensor.
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO engine in a 1997 Ford Taurus
it is in where the timing chain is. mike
Yes, there is a knock sensor on the 2.3L. It is located on the rear driver's side of the cylinder head.
The 1997 Acura intake air temperature sensor is located on the air filter housing. The sensor will be on the right hand side of the air filter housing.
I had a 1997 2.5 GT. It was on the top of the engine block, towards the firewall, but you had to remove some of the air intake system at the top of the engine to see it.
It's under the intake manifold. The whole assembly needs to be removed, it's a complex process.