AIRBAG WARNING: Before you remove any steering wheel parts on an airbag equipped car it is important that you disconnect the negative battery cable to disable the airbag system. A loose airbag deploying directly in your face can cause serious injury, and could possibly kill you DEAD.
Having said that, I'm not sure exactly the procedure on a Seville, but I'll give you a basic run down of how to take off most steering wheels.
1)Disconnect negative battery cable
2)Determine how airbag module is attached to steering wheel. The airbag module is in the front center of the steering wheel and is the part of the steering wheel you see. It likely has a vehicle emblem right on it. There may be plastic covers on the side or back of steering wheel that hide airbag retainer nuts. Some airbag modules are simply held in by clips and can be pulled out. Once you determine how the airbag is fastened remove it from the steering wheel. There will be an electrical connector to the airbag (usually yellow). Carefully disconnect electrical connector and set airbag aside.
2)Disconnect horn wire, and any other electrical wires used inside the steering wheel. There should be connectors for all wires.
3)NOTE:ENSURE STEERING WHEEL IS POINTED STRAIGHT AHEAD PRIOR TO REMOVAL. At this stage you should have access to the steering wheel nut. Remove the steering wheel nut.Some steering wheels will simply come off at this stage. However most wheels must be pressed off. Use a steering wheel puller to pull wheel. A puller set can be rented at most auto parts stores if you don't have one.
4)CLOCKSPRING WARNING:Behind the steering wheel there is a component known as a clockspring. It houses the wires for the airbag and other steering wheel electronics. It allows the steering wheel to spin and maintain electrical connections. It is important that the clockspring or wheels are not turned while the steering wheel is out. If the clockspring is turned too many times over it will break causing steering wheel electronics not to work(and an expensive repair). It must remain centered at all times.
by changing the steering wheel and fixing wats rong wif tha steering
Yank it off
Under the steering wheel, you need to remove the panel under steering wheel.
You need to get a special tool, steering wheel puller. If you have it, disconnect the battery. Remove the steering wheel air bag (there are two screws holding it in place). Disconnect the bag harness. Remove the center steering wheel nut. Using the puller remove the steering wheel. Installation is reversed to removal.
it should be under your steering wheel you might have to remove cover under steering wheel to find it
With extreeme care. I have a steering wheel puller, a phillips driver and a star driver to fit all screws.
how do you fix play in a 1997 mercury mountainer steering wheel
youll have to remove the air bag pad and horn contact pad and steering wheel. there is then underneeth a steering lock plate , yull need a steering wheel puller for(also for remoal of the steering wheel) and also to depress the spring loaded lock plate to remove the c-clip then slowlly release the pressure on the lock plate and remove it underneah will be the signal light switch assmbly.
how to remove a power steering pulley on a 1997 Nissan altima
its underneath the steering wheel... you just need to remove the cover and its right there
You have to remove the steering wheel and driver airbag to replace this multi function switch....trust me I had to do it.
to remove pump on 1997 Bonneville, I aligned holes on actual pulley wheel access holes and reversed bolts.........