Want this question answered?
Advantages of conflict
you dont have to but it makes it a lot easier.
The switch is located inside of the frame, underneath the panel where the shift lever comes up. Remove the knob on the shift lever and remove 2 screws, and remove the plate. The switch is mounted below the Deck Lowering Lever.
Shift the 4 wheel drive lever into 4 wheel drive.
loosen the bolt on the lever, remove the lever and replace in the new angle, then retighten.
Press the shift lever detent button then lift up sharply
Simply start the vehicle with the shift lever in the Park position. If you wish to go backward place the shift lever in the R location. When you're ready to move forward place the shift lifter in the D position. Only shift from park to reverse or to drive when the vehicle is sitting still.
* Remove the shift lever knob,console and shift boot * Disconnect the shift and select cables from the shift control assembly * Remove the large shift cable retainer plate and detach the cables from their bracket on the shift control assembly base * Remove the shift control assembly retaining nuts and remove the shift control assembly
The actuator on a 4-wheel drive allows the vehicle to shift into 4-wheel drive with the push of a button or a shift of a lever. The actuator allows the front axle to become engaged.
Assuming that it is anautomatic And it's just the shifter that you want, at the bottom of the shifter by the steering column there is a pin. Take a punch and drive the pin out.
* Disconnect the negattive battery cable.On airbag-equipped models also disconnect the positive cable then wait three minutes before proceeding * Raise the car and support it securely on jackstands.Remove the cataltic converter heat shield * Disconnect the support and control rod from the transaxle * Remove the nut and bolt tht attach the control rod to the shift lever.Disconnect the return spring,remove the nuts that attach the support rod to the shift lever socket and mass damper and remove the shift linkage assembly * Remove the console.Detach the shift lever dust boot from the floor,pull out the shift lever and slide off the dust boot,seat,insulator and shift lever socket.
Grab lever, pul into 4wd position.