I think you mean the inside dooor Panels.
Find all the retaining screw. Pop out the Panel with the Lock and Window Buttons and look in hear for a screw. I can't remember wher all the screws were. Seems like another behind the lock lever or the door handle. Any way the key is to lift the panel up to remove once the screws are located and removed. Do not pull on the panel or use one of those removal tools like you do on other GMs as you will break the plastic tabs. I found out the hard way.
John Boy Walton
star by taking off the side door panels then take of the corner panel then remove a 1/2 srew and there its off star by taking off the side door panels then take of the corner panel then remove a 1/2 srew and there its off
Go to the Crutchfield website- they have instructions for most vehicles about how to remove interior panels and door panels to do-it-yourselfers can install the parts they sell- great resource-
How change door handle,drive side jetta 97
Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). (Triangle looking shape near the side view mirror) 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. The installation is the reverse of the removal.
rear window defroster relay in a 97 Pontiac firebird
Door handle to what?
no, after '93 the interior style changed along with the door panels, they will fit on the door, but you will not be able to close the door unless you have the '94 and up dash
You don't remove the inner door panel, it's a stamped single piece, however the outer door panel is removed by:Disconnect the door handle by lifting it then press the retaining pins out. Examine the handle at the base, where it connects in to the door. The small pins press out easily using a small rod with a flat surface.After the door handle has been removed, open the door and remove all of the screws around the perimeter of the door skin.You can access any of the internal components of the door from the outside.
Yes the power door can be used as it is the same as your door but you will have to switch the hardware inside of the door and use your hardware from your non power windows, everything will fit from your door into the power door.
Begin by removing the inside door panel on your 1997 Plymouth Grand Voyager. Remove the door lock linkage. Remove the door lock retaining bolts. The door lock will come out.
Remove the door panel, take off the ten millimeter bolts holding the passenger mirror to the door and install the new one. Put everything back together. Door panels are can be tricky to take off without scratching or breaking anything though.
Pop door panel to get access to clip behind it.