Quote I read by $uperpuma on Sound Domain forums, regarding a good place to run an amplifier power cable through your firewall:
"If I remember correctly there should be a great grommet on the passenger side behind the BCM. the bracket on the wheel well opens on either side of the module, pull it up and to the side..."
u cant
How do you remove the headlight assembly on a 2001 camaro?"
You don't. This is regulated by the BCM.
BCM is in the trunk. all the way to the right. You have to remove the panel to get to it The PCM is under the dash on the right side. You have to remove the glove box to access the screw that holds it in place.
How do I remove the rear shocks on a 2002 chevy camaro convertible?
Find them and remove them
The BCM is located behind the glove compartment so you would have to remove it to see the bcm it is a aluminum box. you can get one like I did at the salvage yard. I paid 50 and it has a 90 day warranty
BODY CONTROL MODULE REMOVAL Disconnect battery negative cable. Remove lower steering column cover and knee blocker reinforcement. Disconnect two wire connectors from bottom of Body Control Module (BCM) Body Control Module . Remove bolts holding junction block to dash panel mounting bracket. Remove junction block from mounting bracket. Remove screws holding BCM to junction block. Slide BCM downward to disengage guide studs on junction block from channels on BCM mounting bracket. Remove BCM from junction block. INSTALLATION Reverse the preceding operation The BCM is located near the parking brake behind the drivers side kick plates (mentioned above) It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
remove emissions
It is necessary to either remove the passenger side fender or inner wheel well to access the heater fan in a 68 camaro.
Unplug it, remove the two screws and take it out.
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket