Remove the oil pan and there it is...
Place a drip pan below the oil pan in your 1988 Chevrolet. Remove the oil pan plug. Allow the oil to drain out. Put the plug back into the bottom of the oil pan. Fill the motor with new oil.
You will need to drain the oil from your 1988 Chevrolet Camaro oil pan. Remove the oil pan retaining bolts. Remove the oil pump retaining bolts. Reverse the process to install the new oil pump.
remove engine should be pretty straight forward after that
You will need to drain the oil from your 1988 Toyota Pickup truck oil pan. Remove the oil pan by removing the oil pan retaining bolts. Scrape the old oil pan gasket off. Clean the oil pan gasket surface. Put the new oil pan gasket on and reverse the process.
Drain oil. remove oil filter and replace with new. remove oil pan. Remove old gasket make sure the area at which the gasket seats are cleaned well and install new gasket with oil pan and fill the motor up with the appropriate type and amount of motor oil.
You can't. The engine has to be lifted to get to the oil pan.
1988 F-250 351 Windsor oil pump is located in the oil pan . You will have to unbolt the motor mounts and jack the engine up slightly to remove the oil pan to gain access .
Drain the oil from your oil pan. Remove the oil pan bolts. There are 24 oil pan bolts. The oil pan will come off.
Remove the oil pan, remove the pump, and replace it.Remove the oil pan, remove the pump, and replace it.
start by removing the crossmember(steel support under oil pan).there is 6 bolts holing it on.then remove exhaust pipe bracket from oil pan and then remove the exhaust flange which is right in front of engine oil pan ,it has 3 bolts.then oil pan is available for disassembly.theres 18 10mm bolts holding it on.good luck
Remove the transmission oil pan Remove the transmission oil pan Remove the transmission oil pan