Should be 2 mounting bolts one on top one on bottom remove these and slide caliper off rotor
Remove wheel loosen and remove flexible brake line to caliper Remove 2 mounting bolts Slide caliper off rotor
Remove wheel, remove the bolt holding brake hose to the caliper, remove the two pins that hold the caliper to the caliper bracket using a 3/8" allen wrench, remove caliper. Inspect brake pads and brake hose for damage, replace if necessary. Install new brake caliper in reverse order. Bleed system.
1. Remove the brake hose to caliper bolt from the brake caliper. 2. Remove the brake hose from the brake caliper. 3. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end. 4. Cap or plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination. 5. Remove the 2 brake caliper pin bolts. Remove the park brake cable from the caliper. 6. Remove the brake caliper from the brake caliper bracket.
Front or rear, remove wheel, remove caliper, remove caliper bracket, remove rotor.
3/8"
Remove the tire and wheel from your 2002 Chevy Malibu. Remove the brake spring and the brake caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.
take the wheel off, remove brake caliper, remove brake caliper bracket and pull the rotor toward you or use a hammer. its not bolted on. it just sits on there.
Remove wheel Re-install 2 lug nuts to hold rotor in place Remove flexible brake line Remove caliper mounting bolts Slide caliper off rotor
There are four steps on how grease a brake caliper on a 1995 Corsica. Some of the step-by-step instructions are purchase a silicone-based lubricant, locate the pins and boots, and then take the pins out.
Remove the tire and wheel from your 1996 Chevy Cheyenne. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
T55
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Properly dispose of the old pad, put in the new brake pad, replace the brake shoe/caliper, put the tire back on and lower the car.