I found this answer at http://autorepair.about.com/cs/faqs/l/bl066e.htm Goto the web site for the pictures. 1. Remove the mirror mount cover, power mirror, manual mirror. Take care not to scratch the door panel. See picture at web page 2. If applicable, remove the regulator handle (A) by pulling the clip (B) out with a wire hook (C). See picture at web page 3. Remove the inner handle (A). Take care not to scratch the door panel. * Pry out the cap (B), and remove the screw. * Pull the inner handle forward and out half-way. * Disconnect the inner handle rod (C) and power door lock switch connector (D) (for some models). See picture at web page 4. Power window models: Remove the pull pocket panel (A). Take care not to scratch the door panel. * Pry out the cap (B), and remove the screw. * Release the hooks (C), disconnect the power window switch connector (D), and the power mirror switch connector (E), driver's side only. See picture at web page 5. Manual window model: Remove the pull pocket (A). Take care not to scratch the door panel. * Pry out the cap (B), and remove the screw. * Lift out the pull pocket. See picture at web page 6. Release the clips (A, B) that hold the door panel (C) with a commercially available trim pad remover (D), then remove the door panel by pulling it upward. Disconnect the security indicator connector (E) (driver's) and courtesy light bulb socket (F). Remove the door panel with as little bending as possible to avoid creasing or breaking it. See picture at web page 7. Install in the reverse order of removal, and note these items: * Make sure the connectors and the courtesy light bulb socket are plugged in properly, and the rod is connected properly. * If applicable, install the regulator handle so it points forward and up at a 45 degree angle with the glass fully closed.
passenger side foot panel
Sit in the passenger seat. On the right side of your right foot is the kick panel.
It is the panel between the engine compartment and the passenger's compartment.
Answer:It's located on the front passenger cowl/floorboard, behind a panel, under the carpet. Remove the passenger kick panel, sill cover, and peel back the carpet. Remove the 10mm bolts that hold the cover down, remove the 10mm bolts that hold the computer to the backside of the panel.
To remove the door panel from a 1995 Honda Accord LX sedan the mounting hardware must be unscrewed. Afterwards the mounting clips can be pulled off along with the door panel.
hi hello
YouTube it
There is an access panel in the car just above the fuel pump. Remove that panel and you can access the pump.
The kick panel on a 1990 Honda accord is the same part as on every modern car in the world. The kick panel is the plastic or metal panel on the interior of the car which protects wiring and other parts of the car from the driver's or passenger's outside foot. This panel is often used as a cover for fuse boxes.
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!
There should be an access panel under the back seat. Remove the panel, then the tank panel to remove the unit for replacement. Make sure that the battery is disconnected first.
yes. to get to it, you probably need to remove the glove box and lower panel.