You need special tools to remove broken keys, but they are simple to make. Find a couple pieces of steel about the size of a spoke from a motorcycle wheel. Then with a bench grinder, grind both sides of one end until it's fairly flat and small enough to fit in the key slot. Next grind a notch in the side to make a hook on the end of your tool. It's usually best to make 2 hooks, or you might need one with just a sharp point on the end. Experiment to figure out what you need, and then make it. I've removed several broke keys over the years, and this is what has always worked for me.
diagrama de timing belt de mirage technica 1.8
To remove the rear view mirror off a 2000 Mitsubishi Mirage first pop off the plastic cover place on the body of the mirror. Than proceed to unscrew the mounting screws.
Buy thre Haynes repair manual for $19.99!!
I assume this question is about the mechaincal part of the keyswitch. Remove the plastic cover under the steering column and keyswitch. Turn the ignition key to run (not start). Underneath the keyswitch, there is a small round hole. Push something like a paperclip in the hole and the ignition keyswitch will pull right out. If this question is about the electrical switch part of the keyswitch, there is a single Phillips screw holding the switch in place, just remove the screw to remove the keyswitch. www.driftmotion.com
Turn car on then let it run and heat up then remove dipstick
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
unfortunately you going to have to remove the battery to get to the headlight bulb. But it is pretty easy besides that.
Possibly, remove the back seat and see for yourself.
White wire coming from the distributor.... remove a section of sleeve from wire and splice the signal wire from tachometer to it!
remove the broken one and replace with a new and working bulbs.
use brake fluid
Take it to a shop. Probably not worth it if you waited too long, so u might need a new motor unless your going to tear it down