If you can get hold of it with needle nose pliers you can slide it out. Otherwise, you will probably need a locksmith.
Dude, you need a new door handle. Sorry.
Flush the lock with a lubricant. Use the handle of the broken key as a guide. Find a thin wire and stiff it along the sides of the broken key part. Hold the wire in place and remove the part.
you have to remove the door panel to access the inner door and remove the entire door handle assembly ( from the inside). Once you've got the handle out, remove the lock cylinder, to access the broken key.
1996 rodeo- how to remove key from lock ignition?
call lock smith
with a barrel lock key
Before the key will come out of the lock. The Keyway should be in the vertical position, the same position it was in when the key was put into the lock. Caution: Be very careful not to damage the dust shutter door at the entrance to the keyway. It is held in place by a small hinge pin and spring. If it breaks, remove the parts from the keyway. Locksmiths: Have experience and tools for broken key removal. AAA Automobile Club locksmiths, may be a good choice.
If the key turns, but the lock doesn't function, then the lock is broken.
Your ignition lock is broken.
Locksmiths have a tool that is basically a hooked piece of thin wire. I had a broken key in the lock that i had to remove so i used a very thin piece of wire and made a small 90 degree bend in it. The idea is to slide the wire (hooked end) along the key and get to the end of the key and get the bent end of the wire hooking the tip of the key. Then simply pull the broken end of the key out. In effect you are using a small,long fishhook to get the key out. Use a pair of pliars to bend the wire. Remember that the wire has to be thin and fairly strong. Coat hanger and bailing wire is much too thick. While breaking the lock, if the lock was damaged then you may have to replace the lock. The key may be jammed in too tightly.
It is not hard, our locksmiths do it on a daily basis. There are two locksmith methods to getting a broken key out of a lock, try a very thin pair of tweezers and work the key back and forth. The second way is two use a really small flat head screwdriver and a hairpin. Take the hairpin and insert it into the lock, push all the way up to the top so that the pins in the cylinder will not get in the way. Then take the screwdriver and and fit it into the side of the broken key. Then pry the key out. Hope this helps.
Removing a ignition lock cylinder from a 2002 ford windstar with no key