Check with a locksmith or see if you can find a tool called "broken key remover" it looks like a little saw blade and the teeth hook on to the key and you pull it out.
Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
Locksmiths have special tools and can remove broken keys from cylinders. Is the cylinder in a door or the ignition? First, make sure the lock is in the off position for ignition or the verticle position for a door. Then shoot in alot of lubricant. Next wiggle and jiggle the key while pulling gently. If not possible, take to locksmith.
The 1994 Chevrolet Blazer S-10 dashboard is held in place with eight retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
where is the fuel pump located and how to remove it on 1994 Chevy S10 blazer
Owners manual, positive.
It is harder then you think. You have to pull the steering wheel and everything. I had to just give in and take it to a mechanic. I took him a half hour and he had all the specialty tools that I didn't.
well did this happen to happen to you too!!
Drain the water from your 1994 Chevrolet Blazer cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
remove column dust covers, along with ignition switch. then remove retaining
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.