You need a set of Torx
The 2002 Ford Focus windshield washer tank is held in place by four retaining bolts. Remove the retaining bolts and the windshield washer hose. Reverse the process to install the new windshield washer tank.
To remove the armrest in a 2002 Dodge Caravan, locate the bolts holding it in place. Remove the bolts and carefully life the armrest off the seat.
To remove the 2002 Hyundai accent rear seats find the tabs that cover the bolts and unbolt them. After the bolts are out lift the seat to remove it from the car.
From the inside.
take the bolts out of it
remove wheel. takeoff brak caliber look for 2 pins that you have to drive out (top and botom) or there may be 2 bolts. Use a pry tool to wiggle off caliber as break pads are holding it on at this poit rotor will pull right off
remove the 30 or so bolts from the pan.
there are bolts on the floor just below the glove box and 2 bolts on the firewall
Yes. Pry up the covers concealing the hinges that allow them to pivot forward, revealing the mounting bolts. Remove the bolts then tilt the seat forward and remove the rear mounting bolts - remove the seat from the vehicle.
Remove the bolts. Replace shock. Tighten bolts to the manufacturers recommended torque setting.
undo the bolts that are holding them in and whola out they come.
there are two bolts that hold brake calipers to a u shaped bracket, remove them and then remove the two bolts holding the u shaped bracket. The rotors will come off at this point.
Begin by removing the oil from your 2002 Chrysler Sebring oil pan. Remove the oil pan retaining bolts. Remove the oil pump retaining bolts. Reverse the process to install your new oil pump.
For my 2002 Ford Focus SE, I needed a 7mm hex key(like an Allen wrench). I could only find a 7mm hex key at my local autoparts store. In fact it seemed the only reason they had the 7mm was for brake calipers.
Remove the belt from your 2002 Chevy Cavalier alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
To remove a 2002 S10 grill, first lift the hood and remove the four bolts that hold the grill in place. Then gently pull off the grill and disconnect the turn signal lamps.
unplug wire remove 2 7/32 bolts remove sensor
u have to remove several bolts. and then work it so you can slide it out.. it takes some effort
I own a 2002 kia sportage I installed warn hubs on it . It is very easy on the 2002 you dont even have to remove the wheels . remove the center cap off of the wheel,then remove the bolts on the old hub remove old hub replace with new hub tighten bolts your done but the center cap will not fit.
Seat bottoms just pop up, has clips. seat back have bolts to remove. Need to remove bottom first.
To remove the cover box to get to the fuel injector on the 2002 Envoy, first remove the intake manifold and the valve cover. You can do this by loosening the four bolts that hold the intake manifold first.Ê
UNDER DASH BEHIND GLOVEBOX. TWO BOLTS TO REMOVE. MADE BY PIONEER.
V6 MODELS # Disconnect the negative battery cable # Remove the drivebelt # Disconnect the electrical connectors from the alternator # Remove the mounting bolts and remove the alternator V8 Models # Disconnect the negative battery cable # Remove the engine cover # Position the cruise control cable and throttle bypass hose asside # Remove the drivebelt # Disconnect the electrical connectors from the alternator # Remove the 2 upper stud bolts and the 2 upper alternator mounting bolts # Remove the 2 lower alternator mounting bolts and remove the alternator
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.