push the lighter in, and when it pops out remove it. and remember IT WILL BE HOT!
It's in the #3 slot and the rear is in the #16 slot.
The owners manual list fuse numbers: 1. Power Outlet (Front) 16. Power Outlet (Rear) 31. Cigar Lighter
To remove the factory radio you need a Phillips head screw driver. You will first remove the screw from the cigar lighter area behind the gear shifter. This is the only screw on the panel that you need to remove right now. Next step you will do is either pry off the panel or pull from where you screwed out and pop off panel. Be carefull not to pull or yank too hard because of all of the wiring to the cigar lighter and your a/c unit. After you have removed the panel you will notice that there is only four screws holding in your factory stereo. Unscrew all four and you will be able to pull it out and remove the wiring in the rear. Thanks..
You have to remove the driveshaft to flat tow a 2wd Jeep.You have to remove the driveshaft to flat tow a 2wd Jeep.
how hard is it to replace the heater core in a jeep liberty limated editon step by step instructions
try 31 for front. and #16 for rear power outlet
Turn it counter clockwise.
To remove the gas tank on the 2004 Jeep Liberty Unlimited, you will begin by draining the tank completely. Remove the battery cables from the vehicle so that there is no chance of spark. Then, remove the gas tank straps from below the vehicle.
take it out of the hole.
Remove transmission oil pan
First remove the vent panel that goes across the top of your dash it will snap out of place. Then remove the two screws that hold the center dash piece (where your radio comes through) in place at the top just in front of the tray on your dash. Then after removing the ash try pull on that dash section. It snaps in and out of place. Then there are 4 screws that hold the cigar lighter panel in place.....there you go.
Jeep Liberty was created in 2001.