There is a retainer clip that you need to get off, and then the handle will pull off easily. You can buy a special tool that gets on both sides and pushes it down, or you can use a pair of nylons or a rag that will get stuck on both ends and pull it down just as easily.
Remove the inside door panel from your 1996 Dodge Avenger. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install your new door handle.
Through the hole that the door handle comes through you can feel a screw. Remove the screw and the handle should come off.
The door handle of a 1996 Pontiac Grand Prix can be replace because broken units will can not be fixed. To replace a handle remove the unit from the door and unhinged the locking mechanism.
Assuming you are referring to the outer door handle, remove the inner door panel and look at the back of the handle. You will see a couple of steel rods attached to the handle, remove these(they just unclip)and move them out of your way. You should be able to see a couple of small nuts holding the handle to the door. Remove these and the handle can be pulled out of the door from the outside.
There should be two screws on the underside f the handle. Remove those, and the handle will come right off.
Remove the inside door panel of your 1987 Chevy. Remove the linkage from the door handle. Remove the door handle retaining bolts. The door handle will come off.
Remove the inside door panel. Remove the door handle linkage. Remove the door handle retaining bolts. The front door handle will come off.
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
To remove the door panel, there are two screws you need to remove which are located under the door handle(the one you use to pull the door to close it) ,the you need to remove the mirror adjusting knob by pulling it out, then remove the window handle ( there is plastic ring around the handle which comes between the handle and the door, you need to pull it up using a screwdriver then simply pull the handle out), then just pull the door handle out with a screwdriver from the edges or preferably with your hands.
You will probably have to remove the whole inside door panel in order to remove the handle. The panels are usually held in place with screws or plastic clips. A Haynes Manual might be helpful.
Remove the screws from the handle and then the door panel will slide up. It has clips that will only let it slide up