answersLogoWhite

0


Best Answer

Use a T-40 Torx bit and unscrew the two bolts retaining it.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a door striker on a 2003 ford expedition?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you adjust the door striker on 2000 f350?

Loosen Nadar pin and move, BUT DO NOT REMOVE


How do you remove the door panel for a 2003 Montero Sport?

how do you remove the door panel for a 2003 mitisbushi montero


Door keyless code reset on 2003 ford expedition?

how do you get the entry codes for expedition eddie bower


How do you remove rear speaker covers on a 1998 Ford Expedition?

If your talking about the door speakers then you will have to remove the door panels to get to the speakers.


How do you repair a 2003 ford expedition door ajar?

wd40 in all door latches and strikers.


Where is the front blower motor resistor located on a 2003 Ford Expedition XLT?

Remove the glove box door and you will see the resisior attached with 2 screws.


How do you find door security code on 2003 expedition?

under the pedals


How do you remove the rear door speakers on a 2003 Mazda 6?

remove door panel, remove speeker.


How do you remove the passenger side door panel off a 2003 expedition Eddie Bauer?

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.


How do you get the door panel off a Ford F-150?

There is an already answered question that says "how to remove the Ford Expedition door panel", Search by Ford Expedition and you will find the answer you need.


How do you replace the rear blend door on a 2003 Expedition?

The Expedition uses the same HVAC system as the Ford F150 pickup truck. The Expedition is a little tricky because you have to remove the center console and floor heat distribution vent to access the actuator motor. Once you remove the motor, you can examine the blend door axle for cracks or breakage. This is a common fail mode on the Expedition. HeaterTreater is the world's leading company for aftermarket blend door fixes and has a product for the Expedition. Additional diagnostic information and pictures are available on the Ford Expedition HeaterTreater Ebay listing or the web site at www.heatertreater.net. There is an inexpensive effective fix available that replaces the cheap plastic door with steel that will outlast the vehicle. cgallen


How do you remove the door panel on 2003 Toyota 4 runner?

To remove the door panel on a 2003 Toyota 4 Runner, locate the screws holding the panel to the door. Unscrew these and lift the panel up and away from the door.