Remove the blown fuse. Replace it with a new fuse.
need to replace fuse for radio not sure which fuse it is
Locate fuse. Remove old fuse with appropriate tool in necessary. Replace with new fuse of similar size and rating.
Shouldn't need to remove the box; just open it's cover and pull & replace the bad fuse.
Remove the fuse and check it with a ohm meter. If you have no ohm meter then just replace it with a new fuse.
Remove the fuse and replace with a new one or check the fuse with an ohm meter. or you can (with motor off) replace the horn relay with the fuel relay and see if it honks if it does its good.
try in fuse box by steering wheel if not remove stereo will have separate fuse with wiring at the back of stereo.
AnswerThe 100 amp fuse is bolted in. You can not simple pull it out with a fuse puller or a pair of pliers. You have to remove the fuse box in the cars engine compartment. Then you need to remove the back pannel and gain access to the back of the fuse. Make sure you disconnect the battery first.Once you access the back of the fuse, simple unbolt the fuse you want to remove. Then you can pull it out and replace it with another.Pull fuses out bottom of fuse box . Then unbolt fuse to replace!! Not that easy for me!!!
You can change the fuse for the cell phone charger by unscrewing the screws on the plug with a screwdriver. Remove the old fuse and replace it with a new one of the same amp. Replace the cover of the plug.
Most automotive stereos have two fuses. There is an in-line fuse on the back of the stereo. Take hold of the fuse container, push both Ann's towards the middle and turn. The container will come open. Remove the fuse and replace it with a new fuse.
locate the fuse box and remove the cover. On the inside of the cover there should be a diagram of the fuse placement.. Remove the radio fuse and replace with the same proper size.
Its a 15 amp fuse in the fuse box under the hood on the passenger side near the front. Its the only 15 amp fuse and it is in a clip. Remove the clip, replace the fuse and then reset the clip.