answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove a handbrake lever on a Hyundai excel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Were is the handbrake adjuster on Kia caren?

adjuster is located on handbrake remove centre consul adjuster on right hand side of handbrake lever carens mk 11 2002-2006


How do i adjust the handbrake on my daewoo nubira 2000 wagon?

The handbrake is ajusted in two ways. Firstly it has rear handbrake drums which can be adjusted. Secondly remove the armreast console from around the handbrake lever and there is an ajustment nut here as well.


How do you adjust handbrake on Citroen C3?

Easy, the adjusting nut is located directly next to the handbrake lever. You simply have to remove the cover to access it. Regards Gary Tetlow


Were is the flasher unit located in Hyundai excel?

Close to the bonnet release lever Hard to get off because of the cramped location.


Adjust handbrake on vectra c?

It is very easy to adjust the handbrake on a Vectra C. All you need to do is remove the rear console and release the handbrake. Under the handbrake is a cable with a white end fitting, push down the end fitting onto the plastic locking device. Then pull the lever and it will be adjusted.


How do you adjust the handbrake on a Hyundai getz?

On a 1.1 GSI 2002 model, remove gear knob, remove gear stick cover, then lift up the round cover, inside where the rear cup holder is located on the centre console. Remove this screw, it has a 10mm head, then the console just pushes back from the front of the car, gently raise the console (its a tight fit), then disconnect the wiring connector to the lighter socket (this pulls off easily). Once you have manoeuvred the console out of the way look at the plastic cover located on the handbrake lever, the two halves can be separated by prising them apart, they are on a hinge at the bottom. Once the covers are separated then you can gain access to a 10mm nut, this is the adjuster mechanism. Take the pressure off the handbrake and slowly adjust this nut until the lever operates with the correct number of "clicks", when operating the lever.


Where is the diagnostic port on an Vauxhall Astra?

It is normally located in the centre console between the gear lever and handbrake lever.


Can you show me how to adjust hand brake on a citroen xsara Picasso lx?

OK........ Handbrake adjustment. The handbrake is normally self adjusting So either the cable/s are stretched, or the pads are well worn, and you have no adjustment left. 5 clicks on lever when applying normal/moderate pressure = correct adjustment. If not, then split apart handbrake lever trim, and remove. (Or break which ever happens first). The plastic surround on the handbrake lever needs to be prised apart on the underneath seam as the top seam has interlaced parts that might break. The floor/carpet panel is prized from the rear edge. Unclip & remove carpet panel surrounding lever, you will then see the adjusting nut, bell crank & cables. Chock front wheels, jack-up rear, AND SUPPORT SECURELY. Apply/ release handbrake 4 times. With lever set on 5th click, check that both rear wheels are locked. If not tighten adjustment nut until both wheels are locked. Release handbrake, check that both wheels rotate. Apply handbrake 5 clicks, check for locking - release, check for rotation. If happy, reassemble.


Fan selection lever disconnected can't adjust from screen to cabin to floor etc on Hyundai excel 1998 How do you reconnect it It's stuck on floor setting Help please?

Refer to the Australian Gregory's Automotive book No 269 and page 229 Hyundai excel (body and ventilation). Sold at any super cheap auto.


Changing handbrake lever on fiat uno 1100?

How Do You replace the hand brake lever on the South African (Nissan Build) Uno 1100 Fire (1992 Model) 1108 cc Engine Spec? The Handbrake Lever doesn't hold up into the Ratchet part anymore and doesn't stay up when handbrake applied as the parts are worn down over the years. I tried Banging out the Pivot at rear of the handbrake lever but can't see what holds the pin in place and wont move, Is there a Split Pin Or Washer Holding it? Thanks Walter


How do you change the handbrake lever on your Renault clio?

this you have to look in your hand book that you have in the car when you buy it


2004 Rav4 handbrake lever loose how do you tighten it?

its normally mechnical so find the steel cable and find the nut on the cable of the parking brake "handbrake" and tighten