no you don't have to its actually like just the hoses and the blower is under the dash
Remove the wiring harness from the back of your 1996 Chevrolet blower motor. Remove the blower motor retaining bolts. Remove the fan from the blower motor. Reverse the process to install your new blower motor.
Remove the wiring harness from the back of your 2005 Chevy Cavalier heater blower motor. Remove the heater blower motor retaining bolts. Remove the heater blower fan.
Remove the wiring harness to the heater blower fan. Remove the retaining bolts. Remove the fan from the blower. Reverse the process to install the new heater blower fan.
how to install a blower motor for a 1994 Toyota pickup
how to install a blower motor for a 1994 Toyota pickup
The heatercore is located on the passenger side under the dash. It is located on the left side of the blower fan. Remove the heater core housing which consists of 5-6 screws. Disconnect the two radiator lines under the hood that run into the firewall. There should only be one bracket holding the heater core in the housing. Remove and replace the heater core in the opposite order. Have a good one.
you will find it in the heater box, also where the blower is. it is easy to remove.
Remove the wiring harness from the back of your 1980 Chevy Camaro heater blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
below glove box remove heater/air conditioning cover then remove blower motor cover
Remove blower motor 97 GMC jimmy
Disconnect the negative battery cable, heater blower resistor wires and blower wires. Disconnect the heater core ground strap at the dash panel.Drain the cooling system and then disconnect both heater hoses at the heater.Remove the seven screws attaching the heater/blower case to the plenum and remove the heater/blower base.Remove the four screws from the heater core shroud, and then remove the shroud and core assembly.Separate the core from the shroud by removing the three screws and core mounting clamps and then separating the two.
heater blower resistor has to be replaced. you have to remove glove boxthe resistor is to the right of the heater blower moter