First remove the dashboard to access the heater box and core! Then reversal of strip down to rebuild.
Begin by removing the water supply hoses from your 1989 Chevy heater core. Remove the heater core retaining bolts. The heater core can be removed.
The water from your 1989 Chevrolet Cavalier cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
No, it is not required. You can remove it and splice the heater hoses together.
No................... Its located in the center of the vehicle but you will need to remove the side panels if equipped and then remove the lower heater core cover and the heater hoses.............
The 1989 Chevrolet heater core can be found behind the kick plate. You will need to remove the passenger side kick plate in order to access the heater core.
first of all you have to drain the coolant out then disconnect the battery. then you have to remove the dash and then the heater box but dont forget to remove the hoses under the hood, after you get the heater box out then remove the heater core, just go in reverse order putting it back
take it to a strret raceing shop!
Disconnect the negative battery cable and drain the cooling system.Disconnect the heater hoses from the heater core inlet and outlet connections in the engine compartment.Allowing residual coolant from the heater core to drain. Cap the openings.Working inside the vehicle, remove the lower instrument panel sound insulator.Remove the heater floor outlet duct screws or clips and remove the duct.Remove the heater core cover by removing the attaching screws and clips.Remove the heater core cover.Remove the heater core retainers and remove the heater core.
Located in back of the firewall in a case, need to pull part of the dash to access.
You fill gearbox thru speedo hole! remove speedo cable housing ( 1 10 mm bolt) and just below gearbox housing. you have to remove the speedo drive with a small flat screwdriver . get a bit of hosepipe about a foot long and a funnel. put in 3 ltrs from empty. speedo drive is directly below air box.
i was wondering if my Nissan maxima has a filter i can change myself 1989 model
How to Set timing on nissan sentra 1600cc 1989 model
under the right side dash. you remove heater lower cover heater core right behind cover there are some hiden screws close to the fire wall good luck
Nissan Figaro was created in 1989.
Nissan Pao was created in 1989.
The 1989 Honda Prelude had 4x100mm offset. The 1989 Nissan 240sx has a 4x114.3mm offset...so, it will not fit.
First you have to remove the Upper and Lower Hoses going into the firewall, those hoses goes to the heater core... you must remove the bottom half of the dash in order to access the heater core... it should be held in with about 4 bolts (im not really sure how many bolts holds it in).
For the HEATER CORE ? No
Where i can find the fuse box diagram for a 1989 nissan maxima
Answering "Where is a oil pump locatedon a 1989 Nissan path finder?"
you should just be able to follow the upper hose to the water outlet then remove the 2 screws holding it on and inside you should see the thermostat
The Nissan 240SX was brought to America in 1989.
Under the hood. Not true. At least on the 1989 it was under the dash on the passenger side were the passenger's feet would be. You remove one cover and the drain pan. Remove a second cover on the left side of the box. The heater core is there. Before removing. Drain all the antifreeze from the radiator and remove the quick connect heater hoses from the heater core under the hood.
How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it