0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the front bumper on a 1994 jeep Cherokee 4 door?
behind the bumper, there are 4 bolts , 2 on each side.
How do you remove a front bumper cover for an odyssey 1995?
1. Remove the two bolts underneath the ends of the front bumper with a socket wrench. 2. Unfasten the six clips underneath the front bumper along the center with a screwdriver. 3. Remove the two clips on the top of the front bumper next to the radiator, using a screwdriver. 4. Unfasten the screw that secures the front bumper to each fenderwell, using a screwdriver. The fenderwells are the void areas where the front tires sit in the vehicle frame. 5. Lift the front bumper off the frame of the Honda Odyssey and set it out of the way.
How do you remove the bumper from the 1989 Chevrolet Celebrity?
To remove the front bumper from a Celebrity: 1. Raise the vehicle as needed and put on stands. The parking brake should be on. 2. Remove the end covers 3. Remove the valence cover. 4. Remove the nuts that hold the bumper to the mounting struts. Be careful to avoid having the bumper fall off onto you. 5. Remove the bumper. Reverse these instructions to put the bumper back on.
How do you remove the front bumper cover from a Oldsmobile Alero?
there are 6 10mm bolts that hold the bumper. you will have to remove your mudcover. then there are 6 bolts on the inside of the bumper (3 on each side by the wheel) and 2 pins that hold it (by the hood release) these you pry of with a flat screwdriver. after removing these you should be able to remove the bumper
How do you remove a bumper from a 1999 escort zx2?
To remove the front bumper on a zx2 , first you need to remove all of the fasteners on the top side of the bumper. ( open the hood and look straight down, remove all of those black plastic retaing screws.) After you remove the fasteners from the topyou need to lay down and get all of those small screws on the bottom/front of the bumper. Basically they just hold on the front splash guard but you need to remove them anyways. Once you take care of the top and bottom side of the bumper you need to remove both of the front inner fender wells. It's usually easier if you remove the wheels first. Once you remove the inner fender wells, get you a 3/8 drive ratchet wrench with a LONG extension. There are two (2) bolts on each side of the bumper, I believe they are a 13mm. Take out all four (4) bolts and then remove the front bumper cover and your done.
How do you remove a front bumper on a 1994 Acura Legend?
there are 4 bolts holding that bumper in place. 2 are accessible through the bumper itself, you may have to remove two square covers depending on the type of bumper. the other 2 are hidden behind the bumper turn signal lights, to remove the lights, you have to look under the light with a flash light and look for the screw holding that light in place.
How do you remove the front bumper on a 2006 civic?
1. Remove upper grill cover clips. (1 on each side by the fender, and two in the middle by the hood release)2. Remove 2 Philip screws, 1 on each side of bumper by the tire.3. Remove the bumper clips below the vehicle.4. Using an Allen key, unbolt the two bolts holding the bumper left. They are located on top of the bumper, in the middle of the front by the hood release.5. Slow pull on one end of the bumper, moving your hand closer to the middle of the front of the car. Then do the other side. Finally just take the bumper away from the vehicle CAREFULLY.*from:http://www.8thcivic.com/forums/do-yourself-articles/9167-removing-front-bumper-ex-coupe.HTML
How do you remove the front bumber on a 92 Acura Integra?
1. Remover bumper turn signals. 2. Remove the corner makers. (they are adhered by 1 screw) 3. Remove the bumper corner brackets. They have 2 screws on each side. 4. Unscrew the 2 screws for the sliders/clips located on each side in front of the front tires. 5. Remove the 4 bolts holding the bumper on. Put something under it to help hold it so it doesn't drop. The bolts are located inside where the bumper lights go. There should be 2 12mm bolts on each side. 6. Now under the lip part of the bumper there should be 6 10mm bolts holding the dust cover on. Remove them and slowly pull the bumper off. You will need to un-clip the sides of the bumper.
How do you remove front bumper Mercedes sprinter?
4 13mm bolts, 2 clips. remove licence plate, 2 bolts there, remove plugs near steps, 2 bolts there. slide ends off clips.
How do you remove front bumper from Mercedes sprinter?
4 13mm bolts, 2 clips. remove licence plate, 2 bolts there, remove plugs near steps, 2 bolts there. slide ends off clips.
How do you remove the front bumper from a 2009 Kia Rio?
Go to the related link. They have all the tech support info for Kia there, and you can register for free. You need the following in order to remove the front bumper: 14 clips 10 bolts 2 nuts 6 screws You also need to use a flat-tip screwdriver to pry the bumper off. Make sure you remove the above first.
How do you remove the headlights from a 1989 Honda CRX?
I just changed one in my 90 Crx yesterday, First open the hood and remove the screws that hold on the corner lights, 88-89 will have 2 screws on the outside off each light, 90-91 will have 1 screw attaching it under the hood, remove the corner lights, then take out the screws that hold in the bumper lights/turn signals and remove them from the bumper. On the back of the bumper, in the front wheel opening, there are 2 Phillips screws on each side, remove them, then going thru the turn signal holes, there are 2 bolts on each side, 88-89 will be 10mm, 90-91 will be 14mm, remove them and the front bumper will come off, there may be some bolts on the bottom front of the bumper attached to the plastic panels under the front of the car, you don't have to take the bumper completely off, just pull it out far enough to get to the 2 bolts under the front of the headlight assy. Remove the 2 bulbs from the back of the headlight, remove the 4 10mm bolts holding it in, 2 on top facing up, and two under the light facing forward, (the 2 under the bottom are the reason you have to remove the bumper) and remove the headlight assy. If you have a new assy off of the same year model it should bolt right on, if it's off a differant year or off a civic, you may have to change the mounting bracket off the old headlight onto the new one. Good Luck!.
