With the key.
very carefully reme it and remove plug and reverse the pro cesure
It is a type of plug/receptacle. Once you insert the plug, you can twist the plug to lock it in the receptacle.
Disconnect the battery. Remove the door panel. unbolt the door lock motor, and remove the wiring plug. Replace the motor and put the panel back on.
There is a wiring harness plug to remove and a jubilee clip at each end.
same as rambler in line 6, drill a 1/4" holl into the plug & use a 5/16' taperd srew remover to lock &unscrew the plug.
if u want to remove a plug you have to be careful that water is not in your hand see that it is dry before u pull the plug thank
do I have to drain the water and oil first before I remove the freeze plug
Because that is the way plumbing works, when you remove the plug the water goes down the drain by force of gravity.
You turn a mortise cylinder lock slightly before removing to release it from the lock housing. There is an obstruction in the lock design to keep the cylinder more secure in the lock. After you remove the holding screw from the lock body you can turn the cylinder slightly to release it and remove from the lock housing. Not all mortise cylinders are designed this way. Some of the cylinders unscrew from the lock housing after releasing the cylinder retaining screw.
There is usually a drain plug on the bottom, release this and the water will come out.
if you have an electrical plug and its a th350. you have a th350C or lock up. it is to control; the lock up soliniod
You need to remove the door panel, the outside handle and lock unscrew the 3 bolts near the latch unplug elect plug and remove..The rear locks u need to remove the window rail on the left side to get lock out its 2 tight with rail installed