Want this question answered?
The radiator drain plug is on the bottom edge of the 1991 Legend. It looks like a wing nut and is on the drivers side.
how to replace a water pump on a 1991 acura legend
The radiator support on a 1991 Acura Integra is held on with several bolts. Use the appropriate sized socket and loosen all the bolts. Pull off the support.
The thermostat is just under the throttle assembly at the front of the engine. You will need to remove a black plastic shield in order to access it. Is it difficult to remove and replace? Should that job cost $100? Would a failing thermostat cause the radiator to crack,leak and overheat on my 1991 Acura?
the same way you remove a regular door panel
Were are the timing marks on a 1991 acura legend
To replace the clutch disc in a 1991 Acura Legend you must first remove the engine from the vehicle. Loosen the pressure plate by adjusting the bolts and remove. Put the new one where the old one was and tighten the bolts.
How do I put a alternotor belt on a 1991 Acura Legend
where do you install a new flasher for a 1991 Acura Legend?"
check your coolant levels and radiator if they are ok make sure it doesn't have a blown head gasket which are very common with these years of the acura legend..
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
The map sensor for the 1991 Acura Legend is mounted on the firewall. It is in a box near the factory strut brace.