You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.
Go to this website. It will show how to remove the door panel.
Magic
Remove the screw under the door latch
Using a screw driver, remove the screws and remove the clips from the door panel. Remove the panel slowly, remove any wire connections, and pull the panel off the door frame.
On the driver and passenger side. There are three screws in the panel. The door latch that opens the door. The door handle you grab to close the door,and one at the very bottom of the panel. That screw is set back in a hole making it hard to see. After removing the three screws start pulling on the panel and it will start popping out away from the door.
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
Yes.
just remove it
Remove the rear door panel.
You need a flat-head screwdriver and a TORX bit to remove the door panel on a 2000 Corvette. Use the screwdriver to remove the rectangular panel behind the interior door pull. Next, remove the two TORX screws. Pull the interior door handle open and use the small slots to pry off the panel. Lastly, use the screwdriver to disengage the bottom clip and pull the door panel off.
Remove the door bezel.Remove the window switch.Remove the door pull trim bezel.Remove the 2 7MM bolts behind the door pull trim bezel.Using a door panel tool, you should be able to remove the plastic clips behind the door panel.
Using a screwdriver, remove the screws from the panel, remove the clips from the panel, and pull the panel away gently. Remove any wiring connectors, and remove the panel from the frame.