answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove a starter from a 1996 gmc Jimmy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the starter located at on a 2000 gmc jimmy?

My 2000 GMC Jimmy is slow cranking. The battery voltage meter is showing charged so I am assuming that the starter is the problem. Where do I find the starter to remove it?


Where is the starter on a 1996 gmc jimmy?

Look at the lower rear end of engine


How do you remove starter from 95 gmc jimmy 4x4?

To change the starter on a GMC Jimmy 95 you must look under the truck and locate the starter. There will be a bar in the way of removing the starter. You will have to remove the two screws and manuver the starter around the bar. This will be tricky so take your time. Once you remove the starter replace with the new one and manuver back in place screw in and your done.


Where is the starter located on a 1996 GMC Yukon?

the starter GMC Yukon?


How do you change the ignition switch on a 1996 GMC Yukon?

howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy


How do you remove radiator from gmc jimmy?

How to remove a bad radiator from a 1992 GMC jimmy 4x44-door,v6 engine?....Thank you :)


What is the bolt pattern for a 1996 gmc jimmy?

5x4.75


Where is the starter on a 2000 GMC Jimmy?

The starter is on the right side of the engine. The right tire needs to be removed to access the starter.


Relay switch on a 1996 gmc jimmy?

There are several relay switch is on your 1996 GMC Jimmy. The brake light relay switch can be found below the dashboard in the engine compartment.


What would make your 96 gmc jimmy not turn over with a good starter and alternator?

a defective starter switch


Where is 2004 GMC Yukon Denali starter?

on top of the starter. you have to disconnect battery then remove starter to replace it


How to remove a starter from 1996 GMC Sonoma?

i have a 91 sonoma. For advice it was easiest to unbolt the the flywheel/flexplate cover. this allows you to wiggle the starter towards the front of the truck and then lower it down. ( you do not need to remove the cover; just move it out of the way.