answersLogoWhite
Starters and Ignition Systems
Chevy Blazer
Chevy Blazer S-10

How do you remove a starter in 1987 S-10 4X4 blazer with 2.8?


Top Answer
User Avatar
Wiki User
Answered 2008-01-10 23:33:46

You must remove the crossmember which is the most work to get to these starters. Much easier with air tools (impact driver) about an hour job to get the crossmemeber and junk around away to work with the starter. The starter is usually two bolts and a shimmy or two. remove them one at a time and lower starter. Repeat the opposite to install.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

How much does a 1987 s10 blazer 4x4 weigh?

A 1987 s10 Blazer 4x4 weights around 10.6. This is going off curb weight.


What does timing set on 1987 Chevy blazer 4x4 2.8 V6?

I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.


87 Dodge Dakota 4x4 starter removal?

You have to remove the steering intermediate shaft and remove the starter from the top.


Is there a trick to removing the starter on a 95 Chevy blazer there just doesn't seem to be enought room to get it out?

On the 4x4 models you will need to remove the crossmember in most cases to get access to the starter. Have a safe way of supporting the engine while you do this.


How do you remove starter on Kawasaki Mule 2510?

changing out the starter 2510 mule 4x4


How do you remove the starter on a 1988 Chevy Blazer S-10 4x4?

1. Jack the vehicle up 2. Remove nuts holding "y" exhaust pipe 3. lower exhaust 4. remove starter bolts(2) and wiring, but only after battery is disconnected 5. Starter will wiggle out of it's position


Where is the solenoid located on a 87' s-10 blazer 4x4?

It is mounted on the TOP of the STARTER.


Do you have to remove the transmission to remove the engine on a 97 s10 blazer 4X4 automatic?

No. You can remove the engine and leave the transmission in the vehicle.


How do you locate the starter on a 91 Chevy s10 blazer 4x4?

Follow the positive battery cable from the battery down, the other end will be attached to the starter.


1987 Nissan truck 4x4 where is the starter located?

above the oil filter ,to the left.


How do you repair the starter drive on a 1991 4x4 5.7L GMC 12 ton truck?

Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft


How do you set timing on a 1988 Chevy blazer s10 v6?

I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.


What 4x4 rims are suitable for a Chevy Blazer?

There are many types of 4x4 rims that are suitable for a Chevy Blazer. The 4x4 rims that are suitable for a the vehicle known as a Chevy Blazer are the Capital Factory Wheel rims.


How do you change a starter on a 1997 Chevy k1500 4x4?

disconnect negative battery cable, remove the two bolts that hold the starter, hold starter up and disconnect wires remove starter and install new starter reconnect negative battery cable


Will a 02 4x4 blazer 4l60e fit 01 4x4 Tahoe?

NO it will not.


Blazer s10 4x4 v6 4.3 vortex new starter car isn't turning over at all no clicking nothing?

battery is dead


What other vehicles have the same egine starter as a 1990 Isuzu trooper 2.8 ltr 4x4 automatic?

89-94 chevy blazer with 2.8


How do you replace a fuel filter in 1987 4x4 Chevy Pickup?

Chevy S10 fuel filterI am looking for the fuel filter on a 1987 Chevy s10 blazer 4x4. I looked at the driver side frame rail and cannot find it. Can anyone help.


1997 Isuzu Rodeo V-6 Starter Solenoid Removal what is the Procedure?

How to remove the starter from a 1997 Isuzu Rodeo 4X4 automatic


Will a transmission from a 85 Chevy K5 blazer 4x4 fit an 87 Chevy k5 blazer 4x4?

can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer


Will a 2000 Chevy s10 blazer 4x4 transmission work for a 1998 Chevy s10 blazer?

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck


1990 Chevy 4x4 s10 blazer firing order?

i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.


How do you replace a starter in a 1992 S -10 blazer 4.3L 4x4 with manual trans?

Easiest to get to through passenger side wheel well. Disconnect battery cable (either one). support vehicle well, remove wheel. remove both wires from starter. use 13mm or 1/2" (same size) i think there is 3 bolts holding it to engine.


How do you remove the lock nut from the hub on a 2000 Chevy S-10 Blazer 4x4?

With a 35mm socket and breaker bar.


What is gross vehicle weight of Chevy blazer 2 door 4x4?

The gross weight for a Chevy Blazer 2 door 4x4 is 5300 pounds. The Chevy Blazer was produced from 1983 to 2005.


Still have questions?