0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the fusible link at on a 1987 Pontiac Bonneville?
its hook to the starter
How many bolts do you have to take off to remove the starter from a 1993 Pontiac Bonneville?
17
How do you change the starter on 1987 blazer s-10 with manual trans?
Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
How do you change a starter on a 1995 Pontiac Bonneville SSE?
how do you change a starter in a 1995 Pontica Bonneville?
How do you replace the starter on a 1987 Ford E-150 Econoline Van?
Disconnect the - battery cable Raise and support vehicle Remove wires at top of starter Remove starter mounting bolts Remove starter
How do you remove a starter from a 1987 Chevy 350 small block?
remove grn from bat. remove bat cable from starter solinoid. remove brn wire from starter solinoid. remove two 3/8bolts from starter to block. tilt nose of starter up and lower. this is most common.
How do you change a starter in an 1987 88 delta Oldsmobile?
disconnect the battery, then the wires from the starter. Then remove the bolts holding the starter to the engine.
How do you replace a starter for a 1987 Chevy S10?
Remove one battery post connection. Remove wires from starter and be sure you know where they go back. Remove large bolts from starter and put the new one back in.
My 2000 Pontiac Bonneville wont start?
show me where the starter relay is are on a 2000 Pontiac Bonneville
How do you install a starter in a 1987 Nissan Maxima?
Remove the negative battery cable then follow the posative cable and find the starter. remove the wires and mounting bolts and work the starter out. Sometimes the bolts are hard to get to.
Where is the starter relay on a 1995 Pontiac Bonneville?
On top of the starter--Looks like a juice can
How do you remove the starter on 1987 Harley Davidson?
Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
