pretty simple, i just did mine. first disconnect battery (remove it) then get help and stand bike up on back wheels. unscrew pull rope assembly take it off by litely tapping with a rubber mallet you'll fine two screws in side ( remove them) next there a splash shield
rite under the engine on the frame 6 screws take it off its a hard plastic , there u will see the starter next remove the red wire. NEXT go to the left side as if you were sitting on ATV were your foot goes, there you'll see a big black plastic case , unscrew it. NEXT unscrew the back fender where it attaches to the foot rest, then remove big black plastic cover, NEXT you'll see two big clutches and a belt. you need a wheel puller to remove the forward clutch. first thing to do to remove clutch is put the shifter in gear so the clutch won't spin then loosen the screw about 3/4 of and inch so the washers can slide back and forth, so now the screw is backed out not complete un screwed. NEXT get wheel puller and attach it you'll need three hands to set puller up, once in place start screwing puller down be carefull not to tork to hard clutch assembly is soft metal could break if over torking. clutch should pop off if not litel tap with hammer. NEXT unscrew back pulley
now remove both clutch and pulley with the belt. NEXT you'll see a big black plastic piece remove screws that you see all of them then remove plastic there you'll see the rest of the starter screws remove them and then take starter out.
good luck
how to remove a starter on 2000 dodge caravan
can some one please help iwant to remove astarter from polaris 425 quad many thanks Hi. If you still need help I recently removed my starter from a 2000 polaris xpedition 425. It's actually quite easy. First remove the seat, then you should be able to pop loose the side panels and remove them. Once you can get in there there should be two bolts holding it to the rest of the engine, and one holding on a positive wire, go ahead and remove those and it should slide out. Mine stuck a bit, but you just have to work with it.
Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
To install a 2000 Yamaha Waverunner XL 1200 starter, first remove the 2 bolts. Then the wires connected to the starter. Remove the starter and replace with new.
Remove fuel tank for access
Remove the positive battery cable from your 2000 Saturn battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
it is behind the starter. You will have to remove the starter to get to it.
Disconnect the - battery cable Raise and support vehicle Disconnect wiring harness at the top of starter Remove starter mounting bolts Twist starter to remove
You will have to remove starter, It is behind the starter in the block.
It is behind the starter, Will need to remove starter to service it.
No.
The starter is located beneath the throttle body. Remove the intake tube, then the starter bolts can be removed and the starter replaced.