first u spark a joint then start taking off the engine components then take off your timing belt then youll have 2 adjust it when ur finished then have another jont puck the police
Remove the water return hose from your 1993 Chevy Lumina water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
The water pump on a 2006 Subaru Impreza is located on the front of the engine, typically mounted to the engine block. To access it, you'll need to remove the timing belt, as the water pump is driven by it. It's advisable to replace the water pump during a timing belt service, as they are often replaced together for efficiency.
The water pump on a 1991 Subaru Legacy is in the engine compartment. It is found at the base of the engine.
ok 1990-1994 subaru legacy engines are basically the same the water pump on mine 1991 is located on the thermostat housing on the bottom of the engine on the lower tube off the radiator so find your lower radiator hose follow it is should go to the thermostat and the water pump is on that
Drain coolant from radiator Remove fan shroud Remove radiator if additional room is needed Loosen fan assembly (do not remove) Remove fan belts Remove fan assembly Bolts for water pump should be accessible now Remove water inlet/outlet hoses if necessary Remove bolts from water pump Remove water pump Clean all gasket material from engine Replace gasket and water pump
Ooh, this is a fun one. The water pump is driven by the timing belt, so you have to remove and replace that to change out the water pump. ~Pengauin
Drain the water from the cooling system. Remove the water hose from the water pump. Remove the belt from the water pump. Remove the water pump retaining bolts.
Drain the water from the cooling system. Remove the water hose from the water pump. Remove the water pump retaining bolts. Remove the water pump. Reverse the process to install the new water pump.
remove belt pump is accessable remove bolts make sure coolant is drained first replace
Remove the belt from your 1993 Chevrolet S 10 Blazer power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts.
no just take it off a few pulleys to give u slack when removing the water pump
located and connected to the fan,drain radiator,remove both ,radiator hoses, remove fan belt,remove fan shroud,remove radiator.remove fan,remove water pump.