Want this question answered?
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
There is a horseshoe-shaped metal clip behind the window crank. You must ply the clip out from behind the crank in order to release the crank itself. I would advise you to remove the crank before unscrewing any parts to the door (the process can be very difficult and this will save time). Some auto stores sell cheap removal kits for this.
Remove the inside door window panel. Make sure the window is on the window track. Make sure the window linkage is not needing repair. Replace the window motor.
jack up front of car remove left front undercar cover sensor found under crank shaft pully remove connector and measure resisitence of sensor aprox 900 to 1800 ohms
how do you remove a toyota sienna 2000 windshield water reservoir tank.
For that you will have to remove the whole window mechanism. Then you will be able to replace the motor. When you assemble the mechanism make sure that you have set up position of the gears properly.
its a pain but pry back the panel so you can see behind crank use a flat head screwdriver and a towel so you dont scratch it. inside the crank is a small U shaped clip get some small needle nose plyers and pull it out.,
from the top
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
You will have to replace the complete window regulator assembly.
If you push back the door panel, you should see a retaining clip behind the center of the crank. Pull it out with a small needle nose pliers.
How difficult is it to replace a 2000 Toyota Avalon window washer pump and where is it located?