answersLogoWhite

0

inside the bonnet behind where the bulbs are there will be a big plastic cap and if you twist it you will have access to the cluster of bulbs.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you remove rear light on ford mondeo mk4?

To remove the rear light on a Ford Mondeo MK4, first, open the trunk and locate the access panel or cover behind the light assembly. Unscrew or unclip the panel to expose the rear light fixing screws or bolts. Remove these fasteners, then gently pull the light assembly away from the car body. Finally, disconnect the wiring harness to fully detach the light unit.


Replace the center brake light on 98 altima?

The 1998 Nissan center brake light is a sealed unit. The entire brake light unit will need to be replaced. Remove the wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light unit.


Where is the flasher unit in Skoda octavia?

the flasher unit is built into the hazard light switch on dash you have to remove the small cover around switch unit & remove switch remove plug from back & replace whole unit


How to Remove sharan rear light unit?

With utmost care :)


How do you remove and replace a headlight switch on a 1994 Ford Tempo?

there is a pin on the switch which must be depressed to remove the unit from the dash.


How do you change the brake light on a 2004 Kia Rio?

Access the trunk area and remove the plastic side pockets. Remove the nut that is holding the thru screw. Go to exterior and remove the two holding screws, the light unit will now become loose. Pull on the unit to release the plastic "holdown" and the light unit will pop out. Replace the lights.


How do I remove the flasher unit on a ford laser?

To remove the flasher unit on a Ford Laser, first, locate the flasher relay, which is typically found in the fuse box under the dashboard or near the steering column. Disconnect the battery for safety, then gently pull the flasher unit out of its socket. If it’s secured with clips or screws, carefully remove those before lifting the unit out. Finally, replace it with a new flasher unit if needed, and reconnect the battery.


How do you remove a tail light cover that is glued onto the tail light?

The short answer is you don't. The entire unit is serviced as a unit, individual parts are not available new.


How do you change a rear indicator bulb on fiesta?

To change the rear indicator bulb on a Ford Fiesta, first, open the rear hatch and locate the light assembly. Remove the relevant access panel or screws to detach the light unit from the vehicle. Twist the bulb holder counterclockwise to remove it, replace the old bulb with a new one, and reassemble the light unit by reversing the steps. Finally, test the indicator to ensure it’s functioning properly.


How do you remove the high level brake light unit on a skoda fabia 2009 estate?

To remove the high-level brake light unit on a 2009 Skoda Fabia estate, start by opening the tailgate. Carefully pry off the plastic cover surrounding the brake light unit using a flat tool to avoid damaging the clips. Once exposed, disconnect the wiring harness and remove the screws or clips securing the brake light unit in place. Finally, gently pull the unit out to complete the removal.


How do you remove the rear passenger light in a citroen Picasso?

To remove the rear passenger light in a Citroën Picasso, start by opening the rear hatch and locating the light assembly. Remove the screws or bolts securing the light unit, then gently pull the assembly away from the body of the car. Disconnect the electrical connector by pressing the tab and pulling it out. Finally, replace or service the light as needed before reassembling the unit.


How do you remove the front hub unit on a 2000 Ford Focus?

The hub is pressed in. Remove the knuckle with the hub and bearing in it and take it to local machine shop.