answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove an ac accumulator on a 1987 bronco II?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does 1987 ford bronco II have air bags?

no


What is the timing for a 1987 Ford Bronco II?

if, you have the 2.9 it is 10 btdc


What is the Gas mileage 1987 bronco II?

Mine gets about 19 hwy


Will a 1987 Ford Bronco II 2.9 engine interchange with a 1990 Ford Bronco II with a 2.9 engine?

yes they will interchange . you should have mo major problems switching them.


How do you change a heater core in a 1987 Ford Bronco II?

change out the heater core


What kind of diesel engine can you put in a 1984 Bronco II?

A small 86 HP 2.3L 4-cylinder diesel engine was offered through 1987 on Bronco II's. Bronco II's were made from 1984 to 1990. so if you find this engine it should fit your Bronco II. I researched this before i answered your question so i knew it would be correct!!! good Luck!!! A small 86 HP 2.3L 4-cylinder diesel engine was offered through 1987 on Bronco II's. Bronco II's were made from 1984 to 1990. so if you find this engine it should fit your Bronco II. I researched this before i answered your question so i knew it would be correct!!! good Luck!!!


How many fuel injectors does a 87 bronco II have?

The 1987 2.9L V-6 has SIX injectors.


How do you remove the power window motor passenger side on a 1987 Bronco II?

just did this on a 1988 bronco II. I did the following: remove door panel carefully remove plastic water proof sheet...do not tear...so you can reuse. to remove the motor, i had to drill access holes to get to the three bolts that attach the motor to the regulator. these are 8mm bolts. I located the three bolts and I drilled 1/2 inch holes to access the bolts...this allowed me to remove the motor from its mounting...then unplug from wiring harness.


Will a windshield from a 1987 bronco II fit a 1989 bronco II?

yes they should be the same. but to make sure call your local junk yard they have crossover books that will tell you all that. just ask what years will fit it


Is a bronco 1 or 2 bigger?

There is the FULL SIZE BRONCO and then the Bronco II ( the Bronco II is smaller , eventually replaced by the Ford Explorer)


Why wont your electronic 4x4 engage on your 1987 ford bronco II?

where may i get a wiering diagram of 1987 bronco11 4 wheel drive touch and go system


How do you remove the hydraulic clutch cylinder 89 ford bronco II?

Remove the exaust pipes. Remove the transmission. It is located inside the bell housing section of the transmission.