make sure the tank is empty remove the straps their is only 2 support the tank with a jack remove the tube for the filler take the lines off and electrical. drop tank.
Be careful when you drop the tank , because on the top side of the tank at the front there is a return valve with a hose feeding it . I didn't know it was there and dropped the tank and snapped off the nipple that the hose is connected to .Cost around 30 bucks to replace it , but GM is the only ones that make this part , or so I was told .
Changing spark plugs is an easy task. Disconnect the battery, disconnect the cables, remove the old spark plugs, put in the new spark plugs, reconnect the cables, and reconnect the battery.
Disconnect the battery cable. Remove the bolts that hold the starter in place. Disconnect the wires. Instahlation is in reverse.
Disconnect and remove the battery. Cut off the spoiled terminal and replace. Replace battery. Reconnect.
Spark plugs in a car need to be replaced every once in awhile. To replace them, disconnect the battery, disconnect the cables, remove the old spark plugs, replace with new spark plugs, reconnect the cables, and reconnect the cat battery.
Disconnect the - battery terminal Raise and support vehicle Disconnect the wiring harness at top of starter Remove mounting bolts Drop starter
disconnect negative battery cable, remove the two bolts that hold the starter, hold starter up and disconnect wires remove starter and install new starter reconnect negative battery cable
Disconnect the battery, remove the spark plug cables and covers, and remove the old spark plugs. Next, put in the new spark plugs, reconnect the spark plug cables and covers, and reconnect the battery.
Disconnect the 98 LeSabre battery. Remove the alternator belt. Remove the alternator wiring. unbolt the alternator, remove it, and bolt the new one on. Reconnect the wiring, but the belt on, then reconnect the battery.
Disconnect the battery. It cannot blow without the battery. Same when putting it back. Make the electrical connections and install the airbag then reconnect the battery.
Disconnect the negative battery cable from the battery, remove the two bolts from the starter, drop the starter enough to disconnect the wires from it and remove the starter from the engine.
Most Ford trucks are the same. First thing you do, is disconnect the battery cables. Then get underneath the truck, disconnect the negative cable from the starter. Remove the 2 bolts holding the starter. Remove, and replace the starter, and reconnect the negative cable to the starter, then reconnect your battery.
Remove the inner kick panel. Disconnect the wiring harness. Drive the pins out of the hinges - remove door.