0
How do you remove and install a rear hub assembly on a 1997 Toyota Corolla and is a used hub and bearing from the salvage yard ok to use?
Wiki User
∙ 19y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change the front wheel bearings on a 1991 Olds 98?
YOU HAVE TO TAKE THE HUB ASSEMBLY OFF AND HAVE A SHOP PRESS THE BEARING,OR REPLACE THE HUB ASSEMBLY FROM A SALVAGE YARD.
Where do you find corolla car doors?
Salvage yard is your best choice.
What would be your best bet for a broken ebrake handle spring and button assembly?
AnswerWhy not get the whole assembly at a salvage yard?
How do you install a passenger seat belt buckle not the belt in a 1988 dodge dynasty if you could get an answer this would be very helpful thanks?
I don't see how you could install just the buckle. I suggest you go to almost any salvage yard and get a replacment belt/buckle assembly. Replace the whole thing.
Where is the inertia switch on a 90 Toyota Corolla?
This information can be found in your owner's manual. Don't have one, get one. Dealer or salvage yard is a source.
How do you replace a headlight mount on a 1996 Corolla?
It's probably easier to just buy a whole new headlight assembly. Ebay has some good deals, otherwise they're usually $75 ordered through a salvage yard (aftermarket parts). I have a 96 Corolla w/ a busted headlight mount and I haven't been able to find any way to deal with it other than to just buy new.
How do you fine a replacement part 1986 Ford Econoline Emergency Brake Assembly including foot pedal?
salvage yard?
Recoiling rear seat belt that has been stretched to far?
Purchase a good used belt assembly from a salvage yard.
How hard will it be to install power windows on a 1996 corsica?
SPAL makes an aftermarket kit to change to electric windows, or you can take all the parts required out of a Salvage vehicle and install them.
Where can you find the whole clutch pedal assembly for a 83 Chevy s-10 v6 4 wheel drive?
Salvage Yard.
How do you fix engine knock for Opel corsa classic 1.6 2005?
Assuming this is a bearing knock, remove the engine, disassemble engine, inspect, replace or rebuild worn parts (crankshaft, bearings, etc), reassemble engine, install engine. Or, you can go with a good used engine if you have a reputable salvage yard you can trust.
How do you replace the ignition switch assembly on a 1990 Chevy half ton truck?
If this has the locking tilt wheel it is better to find a salvage yard and get the entire steering assembly . Can get for around $100. Parts and time for replacing the Ignition assembly if you can do it at all will not be worth the effort.
