0
This information can be found in your owner's manual. Don't have one, get one. Dealer or salvage yard is a source.
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
Where is the inertia switch for a 90 Chevy Suburban 1500 with a 350 motor?
Chevy did not use an inertia switch. It don't have one.
How do you replace manual transmission fluid on a 1999 Toyota Corolla CE?
I just called Toyota, it uses 75w-90 Gear Oil.
What type manual transmission fluid for 1991 Toyota corolla?
SAE 75/90 (synthetic is better but not required)
What kind of transmission fluid does 1996 Toyota Corolla take?
The Toyota Corolla requires Dexron III transmission fluid in automatic transmissions. Corolla manual transmissions, on the other hand, use Hypoid API GL-5 (75W-90) for the 4A-FE engine, and API GL-5 (75W-90) for the 7A-FE and 1ZZ-FE engines.
At what amount of km's does the timing belt on a 1999 Toyota corolla need to be changed?
About 90 to 100 thousand km run
What tipe Transmission fluid on 1997 Toyota corolla?
You can use Dexron II or III for an A/T, and 80W-90 for a M/T
Would Toyota Camry coil springs fit on a corolla?
I am 100% sure that the rear springs from a Camry can fit a Corolla (case in reference 93' Camry springs on 90' corolla)but I haven't tried the front springs yet so I am not sure about that one
What Type of transmission fluid for 2002 Toyota Corolla with manual transmission?
Gear Oil API GL-4 or GL-5. 75W-90
What are the cylinder head torque specs on a 1990 Toyota Corolla?
Depending on the model/engine type, the cylinder head torque specs for a 1990 Toyota Corolla are: For the 4AFE (1.6) coupe/sedan/wagon: 44 ft lbs For the 4AGE (1.6) GTS coupe: 1st: 22 ft lbs 2nd: additional 90 degrees 3rd: additional 90 degrees
What are the torque setting for head studs of a Toyota corolla 2003 VVTI 1.4 engine?
standard torque on any head is about 80 lbs to 90 lb torque
What is the torque specs on head gaskets for 1997 Toyota Corolla?
The torque specs for the head bolts on a 1997 Toyota Corolla goes in three simple steps: step one- tighten the bolts in the the correct order to 22lbs step two- in the same order, turn each bolt 90 degrees step three- go through and again in the same order turn each bolt in an additional 90 degree.
Where is the inertia fuel shutoff switch on a 90 Ford F150?
It is on the drivers side floorboard, up under the dash near the fuses. It is a black piece of plastic with a red switch on top. Get a flashlight, you should see it.
