I wasted way too much time for directions on the web, and found nothing. So here's what I did - it's probably not how Honda would tell you to do it. I bought a new window for about $80 (dealership or website).
My window was smashed, so this describes how to put a new one in. It also tells you how to replace the small triangular vent window.
Remove the bolt (10mm) and bracket that holds the bottom of the rear vertical window track. All you see is the bolt head, but there's a spacer between the inside of the door and the track. You can just reach inside and get it when you take the bolt out. Then if you gently lift the gasket away from the top of the track, you'll see a small screw that you need to remove. Then pull the main window gasket out (from the corner near the screw) enough to move the vertical track a couple of inches towards the front of the car. Pull the small triangular vent window out.
Then you can put the new window in, placing the edges it into both tracks. Place the two bolts at the bottom of the window into the regulator bracket holes. No need to adjust the bolts - they just slide into the holes on the bracket. I put the triangular window back in then, screwed the top of the slide back in, pushed the gasket back into place.
You might want to raise the window slowly, and/or leave the bolts a little slack, in case something needs to be adjusted. Good luck. pafricana@hotmail.com
Remove the inside door panel. Remove the wiring harness from the window motor. Remove the track linkage. Remove the window motor retaining screws. Reverse the process to install the new window motor.
To change the front passenger window weatherstripping on a Honda Civic first open the door. Pull the old stripping off and remove the door panel. Use a water proof sealant and place the new weatherstripping around the window.
You can get glass at any junk yard or Honda dealership. At the dealership you will probably pay $200 or more, at a junkyard probably around $75 or less. To replace a window you would remove the door panel first (the plastic covering on the inside of the door). You remove about 5 screws from the door, then start at the bottom and pop the panel off by pulling out. On most cars you need to lower the window to a certain height to access the bolts that hold it in place. You then remove the bolts and tilt the window on its side to remove it. Install in the reverse order.
how to remove front passenger seat of 1996 Honda Civic EX 2 door coupe
Break the window with an iron wrench.
How do I remove and install transaxle assembly for 2004 Honda odysee
Remove your 1998 Honda rear window brake light cover. Push the light bald in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
You will need to remove the door panel from your 2001 Honda Civic. Remove the site view mirror wiring harness. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.
very carefully
YouTube it
If you do not see one above the door window it does not have one.
Depends on what is wrong with it.