Want this question answered?
If the 2007 Ford Edge is equipped with a block heater, the plug and cord are located in the engine compartment. It should be on the passenger side, towards the front of the vehicle.
With a big hammer. hit it on the edge
remove corner trim it pops off remove door panel screw in compartmnet on edge and by handle unplug remove three screws and replace
You must remove the tail lamp assembly to replace the bulbs, Open the liftgate, there are 2 screws on the inside edge of the light, with the 2 screws removed pull the tight straight back to remove it. There are 2 locking pins on the right side of the light which may take some effort to release.Source: http://repairpal.com/remove-tail-light-cover-424
First make sure that the clamp is tight enough on the hose or that it's not defective or damaged
NASA EDGE - 2007 was released on: USA: 19 March 2007
The 2007 Ford Edge has 24 valves.
The 2007 Ford Edge has a V6 engine.
Open the rear hatch there are 2 screws on the inside edge of the tail light remove them then remove the light housing. Unscrew the plug at the back and replace the bulb. Good Luck James
The 2007 Ford Edge is a gas-powered vehicle.
The 2007 Ford Edge has a 6-speed automatic.
The 2007 Ford Edge has a 16.0 degrees angle of approach.